Handleiding
Je bekijkt pagina 25 van 90
Air Conditioner
Features
SLEEP FEATURE:
TO ADJUST FAN SPEEDS:
Page 24
FOLLOW ME FEATURE:
Light flashes or
illuminates
Cooling Starts.
at which time the compressor turns back on and
room temperature is above the set temperature,
on
for 2 minutes at 10 minute intervals until the
after
the compressor shuts off.The fan then cycles
modes.
The fan will continue to run for 3 minutes
AUTO (only AUTO-COOLING and AUTO-FAN)
function.
This function is available on COOL, DRY,
Press / Energy saver button to initiate this
ENERGY SAVER FEATURE:
Filterbutton and the light will go off.
resetafter cleaning the filter, press the Check
willilluminate after 250 hours of operation. To
Filterfor more efficient operation. The LED (light)
feature.This feature is a reminder to clean the Air
Press Check filter button to initiate theis
CHECK FILTER FEATURE:
can not beadjusted.
mode is shifted.For some models, the fan speed
Each time thebutton is pressed, the fan speed
four steps: Auto, Low, Med or High.
Press Fan button to select the Fan Speed in
pressing
the
fan
button.
selected,
the
fan
speed
can
be adjusted
by
desired
temperature. When
Cool
Mode
is
Use
the Up
and
Down
buttons
to
choose
the
• Choose Cool
Mode
to
set
the
cooling
function.
Auto-Fan) modes.To operate on COOL mode:
Cool, Dry, Auto (only Auto-Cooling and
automatically the Energy
Saver function under
once the mode
is selected. The unit will initiate
light beside will
be illuminated and remained on
Cool, Dry and Fan. The indicator
is
selected in a sequence that goes from Auto,
button.
Each time you press the button, a mode
To choose operating mode, press Mode
TO SELECT THE OPERATING MODE:
mode has ended.
the unit will beep to indicate the Follow Me
Follow Me signal during any 7 minutes interval,
button again.If the unit does not receive the
3 minutes interval until press the Follow Me
will send this signal to the air conditioner every
temperature at its location. The remote control
Follow Me button. The remote display is actual
remote control towards the unit and press the
To activate the Follow Me feature, point the
temperature control at its location.
remote thermostat allowing for the precise
control ONLY. The remote control serves as a
This feature can be activated from the remote
pressing the sleep button again.
cancelled at any time during operation by
programmed. The sleep mode program can be
unit will continue to operate as originally
temperature. This ends the sleep mode and the
before it returns to the originally selected
temperature will be maintained for 6 or 7 hours
after an additional 30 minutes. This new
decrease (heating) by another 2
°
F/1 (or 2)
°
C
The temperature will then increase (cooling) or
(or 2)
°
C 30 minutes after the mode is selected.
increase (cooling) or decrease (heating) by 2
°
F/1
In this mode the selected temperature will
Press sleep button to initiate the sleep mode.
Bekijk gratis de handleiding van Keystone KSTAW08CE, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Keystone |
| Model | KSTAW08CE |
| Categorie | Airco |
| Taal | Nederlands |
| Grootte | 15608 MB |
