Handleiding
Je bekijkt pagina 18 van 90
Installation
Instructions
Page 17
1/2 L
ong Screws
And Locknuts
Left
Right
Sill Angle
Bracket
Flat Head
Bolt
2 Each Required For
Each Support Bracket
Locknut
Mark
1 2 Long Screws
and Locknuts
5
Side Louvers
Window Sash
Window Sill
Sill Angle Bracket
1 5
About1 / to1 /
4 8
Measure from
the cabinet edge.
3 4 (or1 )Long
Hex-head Screw
/2
3. Install support brackets(with sill angle brackets
attached) to correct hole in bottom of cabinet as
shown in Fig.16.
4. Tighten all 6 bolts securely.
1. Carefully raise window to expose filler panel
locking screws. Loosen screws so filler panels
slide easily.
2. Extend panels to fill window opening
completely. Tighten locking screws on top
(Fig.17).
3. Close window behind top angle.
Fig.13 Fig.13B
Fig.15B
Fig.16
Locking Screw
7/16"Locking Screw
and Washer
Fig.17
Fig.14
Fig.15A
5
Install Support Bracket
6
Extend Window Filler Panels
use,correct the slope otherwise (Fig .14).
not drain from the overflow drain hole duringnormal
outside). After proper installation, condensate should
1
1
/
4
"to 1
5
/
8
" (tilted about 3
°
to 4
°
downward to the
NOTE:
Check that air conditioner is tilted back about
Hand tighten, but allow for any changes later.
at the marked position(Fig.15B).
2. Assemble sill angle bracket to support brackets
remove.
Fig.15A. Mark brackets at top level of sill and
of sill, and tight to bottom of cabinet as shown in
1. Hold each support bracket flush against outside
Bekijk gratis de handleiding van Keystone KSTAW08CE, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Keystone |
| Model | KSTAW08CE |
| Categorie | Airco |
| Taal | Nederlands |
| Grootte | 15608 MB |
