Karcher KIRA B50 handleiding
Handleiding
Je bekijkt pagina 6 van 20
6 English
1 Drain for waste water
2 Docking station base
3 Lower part of docking station
● Adjust to the ground conditions with the help of the supplied
washers (5 per screw foot).
Note
4 more washers are additionally enclosed.
● Tighten the screws on each side.
● Connect the drain for waste water to the waste water disposal
equipment. Observe local regulations for waste water treat-
ment and disposal.
1 Socket for non-heating apparatus
2 Water connection
● Connect the enclosed hose to the water connection.
Note the flow direction (arrow).
● Connect the enclosed mains cable to the socket for non-heat-
ing apparatus on the unit.
1 Screw
2 Bar cover
3 Mains cable
4 Hose
5 Upper part of docking station
● Tighten the screws on each side.
● Attach the cover.
● Connect the hose to the water supply. Note the maximum per-
missible water pressure in chapter “Technical data”. Install a
pressure reducer in the supply line if necessary.
● Connect the mains plug to the socket. The socket must be pro-
tected by a fault current protection switch with a trigger current
of 30 mA.
● Check the function.
Adjusting the height
1 Waste water tank cap
2 Docking station wedge
● Move the unit in front of the docking station.
● Check the height alignment: The tip of the wedge on the dock-
ing station must meet the slant on the cover of the waste water
tank halfway up.
● Adjust the height of the docking station so that the Cliff LiDAR
collision guard on the device fits in under the docking station
with a clearance of approx. 5 mm.
Correct the height
1. Measure the difference dimension to the correct setting di-
mension.
2. Loosen the 4 screws on the docking station and remove it from
the wall.
3. Using the washers, adjust the screw feet on the lower part by
the difference dimension (one washer corresponds to 2 mm).
4. Place the docking station against the wall and fasten it with 4
screws.
5. Recheck the height alignment.
Docking station drain height
Note
Note that the distance between the floor and the height of the
drain of the waste water tank must be 220 mm.
Bekijk gratis de handleiding van Karcher KIRA B50, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Karcher |
| Model | KIRA B50 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 7713 MB |
