Karcher FCV 4 handleiding
Handleiding
Je bekijkt pagina 19 van 234
English 19
1. Step on the floor nozzle and push the upper body to
the upright position.
Illustration J
2. Remove the dirty water tank by holding the dirty wa-
ter tank handle and pressing the release button.
Illustration K
3. Remove the cover from the dirty water tank. Empty
the dirty water tank and rinse it.
Illustration L
4. Push the dirty water tank into the device until it au-
dibly clicks into place. The dirty water tank must sit
firmly in the device.
Refilling the cleaning fluid
If the fresh water tank is empty, the warning "Refilling
Water" flashes on the LED display.
1. Fill the fresh water tank (see Filling the fresh water
tank).
Interrupting operation
ATTENTION
Material damage due to moisture
The moisture roller can cause moisture damage to sen-
sitive floors.
When taking longer breaks, place the device on the
parking station to avoid damage to sensitive floors from
the moisture roller.
1. To pause the device from working, step on the floor
nozzle and push the upper body to the upright posi-
tion. The device vacuums for 5 seconds and then
enters standby mode.
Illustration J
2. If the appliance is pulled back to working position
within 2 minutes, the device starts automatically with
the latest cleaning mode.
Illustration H
3. If the appliance is pulled back to working position
during 2-5 minutes, the device starts with the Auto
mode.
Note
The standby mode lasts for 5 minutes. After 5 minutes,
the device turns off completely.
Ending operation
1. Press the ON / OFF button.
Before the device turns off, it vacuums for 5 seconds
and then shuts down completely.
2. Step on the floor nozzle, and push the upper body to
upright position.
Illustration J
3. Place the device on the charging and cleaning sta-
tion.
Illustration C
4. Clean the device, (see Care and service).
ATTENTION
Adhering dirt deposits
Adhering dirt deposits can damage the device in the
long term.
It is recommended to clean the device completely after
each application.
Storing the device
ATTENTION
Odour development due to liquids in the device
Unpleasant odours can develop if the device contains
liquids/moist dirt when stored.
Completely empty the fresh water tank and dirty water
tank before storing the device.
Use the cleaning brush to remove hair and dirt particles
from the suction channel and inside the floor nozzle
(see Cleaning the floor nozzle).
Allow the cleaned roller to air dry e.g.on the device
mounted on the parking station. Do not place the wet
roller in an enclosed cupboard to dry.
1. Move the device to a dry room.
2. Place the device on the charging and cleaning sta-
tion to charge.
Illustration C
3. Place the cleaned roller on the storage holder to dry.
Illustration O
Care and service
Self-cleaning
ATTENTION
On completion of work, place the device in the cleaning
station and start the self-cleaning process. Clean the
floor head in the cleaning station only by using the auto-
matic self-cleaning process and not by pouring water in-
to the station separately. Do not clean the device or the
floor head under running water or under a shower spray,
otherwise water may enter.
Note
As long the warning "Full tank" icon is shown on the
LED display, and the dirty water tank has not been emp-
tied, the self-cleaning process cannot be started.
1. Empty and reinsert the dirty water tank (see Empty-
ing the dirty water tank).
2. Refill the fresh water tank, to make sure the water
level exceeds the “MIN FOR SELF-CLEANING”
marking.
Illustration M
3. Put the appliance back to the charging and cleaning
station. (The charging and cleaning station needs to
be powered on).
Press the self-cleaning button to start the self-clean-
ing process. The self-cleaning lasts 110 seconds.
Illustration N
4. When the self-cleaning process is completed,
please empty and rinse the dirty water tank, then re-
install the dirty water tank (see Emptying the dirty
water tank).
Note
To stop the self-cleaning process, press the self-clean-
ing button again, or press the ON / OFF button.
Cleaning the dirty water tank
ATTENTION
Adhering dirt deposits
Adhering dirt deposits can damage the device in the
long term.
It is recommended to clean the device completely after
each application.
ATTENTION
Clean the filters regularly to prevent blockage due to
long-term use.
For a better cleaning performance, it is recommended
to replace the filter every 2-3 months.
Use KÄRCHER filter only to ensure proper fit of filter
and dirty water tank, and ensure the device perfor-
mance.
For information on removing and emptying the dirty wa-
ter tank, (see Emptying the dirty water tank).
1. Remove the cover of the dirty water tank.
Illustration L
Bekijk gratis de handleiding van Karcher FCV 4, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Karcher |
| Model | FCV 4 |
| Categorie | Stofzuiger |
| Taal | Nederlands |
| Grootte | 41006 MB |
