Jung SITMA5073 handleiding
Handleiding
Je bekijkt pagina 106 van 140
7.1 Programming – manual
Selection external camera
2 At the BVA650-… hold the
programming button down for
4seconds. After this, the status LED
ashes at short intervals as long as
the programming mode is active.
The BVA650-… is used for actu-
ation of an external video camera
without door station to the Siedle
In-Home bus: Video.
Dialling the external camera can be
programmed as a function to one of
the buttons of a bus telephone.
This function can be programmed
for any bus telephone to any button.
The only exception is the door
release button.
1 Switch on the programming mode.
At the BNG/BVNG650-…, press the
programming mode button briey.
The LED1 ashes in a 2-second
rhythm to indicate that the program-
ming mode is active.
6 Replace the receiver. Continue to
program more bus telephones or
quit the programming mode.
5 At the bus telephone, hold down
the button you wish to use to call
the external camera for 4seconds.
Replace the receiver at the bus tele-
phone. The button is now assigned
to the external camera. The external
camera can be selected at any time.
4 Hold down the light button for
4seconds. A protracted signal tone
is audible in the receiver. The bus
telephone is now in the program-
ming mode. Do not replace the
receiver! The camera picture can be
seen on the monitor.
3 Lift the receiver at the bus tele-
phone which you wish to program.
106
Bekijk gratis de handleiding van Jung SITMA5073, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Jung |
| Model | SITMA5073 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 13662 MB |
