Jung FMGCR1700 handleiding
Handleiding
Je bekijkt pagina 47 van 94
ceiver electronics and available
status LEDs, which are not, there-
fore, used for permanent display.
The communication electronics
themselves are optimised for min-
imal energy consumption. The de-
fining factor for the battery life is
the transmission frequency.
Because of this, wireless transmit-
ters’ battery change cycles cannot
be precisely determined, and vary
between approximately two and
ten years. To prevent users from
changing the battery as a precau-
tion, wireless transmitters indicate
when a battery is flat. Following an
actuation, the status LED flashes
slowly for 3 seconds. Querying of
the actuator status is omitted. In
addition, the wireless transmitters
transmit information about their
battery’s status in their telegrams.
3. UNIVERSAL
TRANSMITTERS
Binary inputs record binary elec-
trical input signals – i. e. power
supply switched on, power supply
switched off. The recognised input
events are converted into wireless
commands.
The eNet universal transmitter
integrates devices with a 230 V
switching output into an eNet sys-
tem. These devices may be devices
with a touch function, which revert
to the resting position immediately
230 V universal transmitter
Input circuit with switching contacts, e. g.
two switches, motion detectors, timers, etc.
Operating mode:
• 2 - K -
, 2-gang automatic functions
Function:
• Close contact: On
• Open contact: Off
after being pressed, or devices with
a switching function, which have
two stable switching positions. The
universal transmitter gets its sup-
ply voltage from the 230 V mains, so
that battery-independent operation
is possible.
The universal transmitter has two
binary inputs. It detects switch-on
and switch-off edges on the input
terminals, and transmits com-
mands to the connected actuators.
Users can choose whether to op-
erate the two inputs as individual
functional channels (two functional
channels with one-surface opera-
tion) or whether to combine them
to create a shared functional chan-
nel (one functional channel with
two-surface operation).
Depending on the operating mode
set, the universal transmitter
transmits commands relating to:
• switching lights or other con-
sumers;
• dimming lights;
• activating a doorbell;
• opening and closing blinds;
• retrieving or saving scenes.
The “Scenes for signal contact” op-
erating mode can also be activated
using the eNet server. This mode
can be used to implement a wind
alarm for blind systems using a wind
sensor, for example.
The universal transmitter can there-
fore be put to highly versatile use.
9594 eNet _ Wireless transmitters
Bekijk gratis de handleiding van Jung FMGCR1700, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Jung |
| Model | FMGCR1700 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 24644 MB |
