JMAZ Centipede Quadro handleiding
Handleiding
Je bekijkt pagina 28 van 45
27
Manual
● Manual
○ With this function, you can manually adjust the value of your desired function.
System Information
● System Information
○ With this function, you can check current fixture on time, fixture total used time, sensor,
temperature, software version (Panel, Dimmer).
Reset
● Reset
○ With this function, you can perform all reset or factory reset.
Network
● Network
○ With this function you can pick your desired network setting.
DMX SET UP
DMX-512: DMX is short for Digital Multiplex. This is a universal protocol used as a form of
communication between intelligent fixtures and controllers. A DMX controller sends DMX data
instructions from the controller to the fixture. DMX data is sent as serial data that travels from fixture to
fixture via the DATA “IN” and DATA “OUT” XLR terminals located on all DMX fixtures (most controllers
only have a DATA “OUT” terminal).
DMX Linking: DMX is a language allowing all makes and models of different manufacturers to be
linked together and operate from a single controller, as long as all fixtures and the controller are DMX
compliant. To ensure proper DMX data transmission, try to use the shortest cable path possible when
linking several DMX fixtures. The order in which fixtures are connected in a DMX line does not
influence the DMX addressing. For example, a fixture assigned a DMX address of 1 may be placed
anywhere in a DMX line: at the beginning, at the end, or anywhere in the middle. When a fixture is
assigned a DMX address of 1, the DMX controller knows to send DATA assigned to address 1 to that
unit, no matter where it is located in the DMX chain.
Data Cable (DMX Cable) Requirements (For DMX Operation): This unit can be controlled via
DMX512 protocol. The DMX address is set on the rear panel of the unit. Your unit and your DMX
controller require a standard 5-pin XLR connector for data input and data output. We recommend
Accu-Cable DMX cables. If you are making your own cables, be sure to use standard 110-120 Ohm
shielded cable (This cable may be purchased at almost all pro lighting stores). Your cables should be
made with a male XLR connector at one end and a female XLR connector at the other. Also
remember that DMX cable must be daisy chained and cannot be split.
Notice: Be sure to follow the diagram below when making your own cables. Do not use the ground
lug on the XLR connector. Do not connect the cable’s shield conductor to the ground lug or allow the
shield conductor to come into contact with the XLR’s outer casing. Grounding the shield could cause a
short circuit and erratic behavior.
Bekijk gratis de handleiding van JMAZ Centipede Quadro, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | JMAZ |
| Model | Centipede Quadro |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 5509 MB |
