Janome Memory Craft 100E handleiding
Handleiding
Je bekijkt pagina 21 van 112
19
5.
Slowly release the needle threader lever to its original
position to pass the thread through the needle eye.
Press the lockout key to unlock the machine.
3.
Pull the thread up and slip it between the thread
cutter and face cover from behind.
Pull the thread toward you to cut.
(5) Thread cutter
4.
Lower the presser foot lifter.
Pull down the needle threader lever as far as it will
go.
(6) Presser foot lifter
(7) Needle threader lever
Built-in Needle Threader
1.
Turn the handwheel toward you to raise the needle.
Press the lockout key to lockout the machine.
(1) Handwheel
(2) Lockout key
2.
Pull the thread up to the left, over the needle threader
guide while holding the thread near the spool with
your hand.
(3) Needle threader guide
CAUTION:
Always make sure to press the lockout key to lockout
the machine or turn the power switch OFF before
threading the machine.
NOTE:
• The needle threader can be used with a #11/75 to
#16/100 needle.
• Thread size 50 to 90 is recommended.
• Do not use thread size 30 or thicker.
NOTE:
If the thread loop is formed after releasing the needle
threader lever, pull out the thread loop through the
needle eye.
NOTE:
Be sure that the thread pass the slit of the needle
threader as shown.
(4) Slit
1.
3.
4.
5.
2.
(2)
(3)
(4)
(5)
(1)
(7)
(6)
Bekijk gratis de handleiding van Janome Memory Craft 100E, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Janome |
| Model | Memory Craft 100E |
| Categorie | Naaimachine |
| Taal | Nederlands |
| Grootte | 24843 MB |
