Janome Memory Craft 1000 handleiding
Handleiding
Je bekijkt pagina 36 van 212
34
5.
Slowly release the needle threader lever to its original
position to pass the thread through the needle eye.
Press the lockout key to unlock the machine.
NOTE:
Be sure that the thread pass the slit of the needle
threader as shown.
(4) Slit
Built-in Needle Threader
1.
Press the needle up/down button to raise the needle.
Press the lockout key to lockout the machine.
(1) Needle up/down button
(2) Lockout key
2.
Pull the thread up to the left, over the needle threader
guide while holding the thread near the spool with
your hand.
(3) Needle threader guide
1.
3.
4.
5.
2.
(1)
(2)
(3)
(4)
(5)
(7)
(6)
CAUTION:
Always make sure to press the lockout key to lockout
the machine or turn the power switch OFF before
threading the machine.
NOTE:
• The needle threader can be used with a #11 to #16
needle.
• Thread size 50 to 90 is recommended.
• Do not use thread size 30 or thicker.
• The needle threader cannot be used with the twin
needle.
3.
Pull the thread up and slip it between the thread
cutter and face cover from behind.
Pull the thread toward you to cut.
(5) Thread cutter
4.
Lower the presser foot lifter.
Pull down the needle threader lever as far as it will
go.
(6) Presser foot lifter
(7) Needle threader lever
NOTE:
If the thread loop is formed after releasing the needle
threader lever, pull out the thread loop through the
needle eye.
Bekijk gratis de handleiding van Janome Memory Craft 1000, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Janome |
| Model | Memory Craft 1000 |
| Categorie | Naaimachine |
| Taal | Nederlands |
| Grootte | 41253 MB |
