Janome Continental M6 handleiding
Handleiding
Je bekijkt pagina 9 van 156
7
(6)
(5)
(4)
(4)
(1)
(2)
(3)
(3)
(2)
(3)
(1)
(1)
(2)
(1)
(1)
1.
2.
3.
Adjusting the Thread Cutter Switch Position
Placing the thread cutter switch to the left.
The thread cutter switch position can be adjusted for your
convenience.
If you wish to attach the thread cutter switch to the left
side of the foot control, follow the procedure below.
3.
Attach the foot control and thread cutter switch with
the setscrews A, B and the washers. Tighten the
setscrews A and B. Be sure that the cable is not
caught between the foot control and the base plate.
(1) Setscrew A
(2) Setscrew B
(3) Washer
Foot Control and Thread Cutter Switch (Optional)
To attach the foot control and the thread cutter switch to
the base plate, tighten setscrews A, and setscrews B with
washers as shown.
(1) Foot control
(2) Thread cutter switch
(3) Base plate
(4) Setscrew A
(5) Setscrew B
(6) Washer
NOTE:
A Phillips head screwdriver is not included with this
machine.
1.
Remove the setscrews A, B and washers with a
Phillips head screwdriver.
(1) Setscrew A
(2) Setscrew B
(3) Washer
2.
Turn the base plate 180 degrees.
Bekijk gratis de handleiding van Janome Continental M6, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Janome |
| Model | Continental M6 |
| Categorie | Naaimachine |
| Taal | Nederlands |
| Grootte | 22107 MB |
