Janome 1522RD handleiding
Handleiding
Je bekijkt pagina 22 van 36
20
c
x
z
Automatic Buttonhole
q Stitch pattern:
w Presser foot: Automatic buttonhole foot
e Thread tension dial: 1–5
r Stitch length: 0.5–1
t Stitch width: 5
* The size of buttonhole is automatically set by
placing the button in the rear of the automatic
buttonhole foot.
* The button holder of the foot takes a button size
up to 1˝ (2.5 cm) in diameter.
* Make a test buttonhole on an extra piece of
the fabric, interfacing and seams of the actual
garment.
* Use interfacing on stretch fabrics.
z Raise the needle by turning the handwheel
toward you.
Raise the presser foot lifter.
Attach the automatic buttonhole foot.
q Groove
w Pin
x Pull the button holder to the back A, and place
the button in it.
Push back the button holder toward you B as
far as it will go.
e Button holder
* If the button is extremely thick, make a test
buttonhole. If it is difcult to t the button
through the test buttonhole, lengthen the
buttonhole by pulling the button holder back to
create a gap.
r Gap
c Pull the buttonhole lever downward as far as it
will go.
t Buttonhole lever
v Insert the fabric under the foot. Turn the
handwheel toward you one rotation and
remove the fabric to the left to draw both
threads to the left. Insert the garment under the
foot, and lower the needle at the starting point.
Then lower the automatic buttonhole foot.
y Starting point
NOTE:
Make sure there is no gap between the slider
and spring holder, otherwise the left and right
length will be different.
u Slider
i Spring holder
o There should be no gap.
!0 Sewing gap
q w e
r t
q
w
r
e
A
B
t
u
o
i
y
!0
v
Bekijk gratis de handleiding van Janome 1522RD, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Janome |
| Model | 1522RD |
| Categorie | Naaimachine |
| Taal | Nederlands |
| Grootte | 3697 MB |
