JANDY JSWC100 handleiding
Handleiding
Je bekijkt pagina 32 van 72
Page 32
ENGLISH Jandy
®
Commercial Salt Chlorinator | Installation & Operation Manual
Section 7. Troubleshooting
NOTE: Turn off power to unit prior to attempting service or repair.
Problem Corrective Action
The production indicator always
shows "0" at any selected
production level
- Check the electrodes
- Check the output connections between power supply and the
electrolysis cell
- Check the salt concentration
The power supply doesn’t switch on
- Check the input connections are properly connected to the mains
- Check the fuse status located at the bottom of the device
The chlorine level into the water is
very low
- Check the chlorine measurement on the nozzles
- Check the chemical parameters into the water (pH,combined chlorine,
isocyanuric acid) are correct
- Increase filtration time
- Add chlorine stabilizer (isocyanuric acid) until reach 50-75 ppm
If issues persist, contact Jandy Technical Support at 1.800.822.7933
Bekijk gratis de handleiding van JANDY JSWC100, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | JANDY |
| Model | JSWC100 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 16458 MB |
