JANDY JSWC100 handleiding
Handleiding
Je bekijkt pagina 24 van 72
Page 24
ENGLISH Jandy
®
Commercial Salt Chlorinator | Installation & Operation Manual
4. Broadcast or spread the salt into the outer
perimeter of the pool, or into the shallow end of
the pool for quick and even distribution.
5. To avoid clogging the filter or damaging power
center and pump, do not add salt through either
the skimmer, main drain, or surge tank.
6. Brush the pool bottom and allow water to
circulate for 24 hours to dissolve completely and
mix evenly with the pool water.
7. After 24 hours, verify correct salt reading with
the test meter.
8. Turn on the system and set to desired chlorine
production rate (pressing the arrow buttons A
orB).
NOTE: For a new concrete pool or newly resurfaced pool
it is recommended to wait 30 days (surface should
be completely cured) before adding salt. Follow
the pool surface manufacturers guidelines for your
particular pool. For vinyl and fiberglass pools, salt
can be added at start up.
Bekijk gratis de handleiding van JANDY JSWC100, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | JANDY |
| Model | JSWC100 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 16458 MB |
