Jackson FlightStar handleiding
Handleiding
Je bekijkt pagina 32 van 90
07610-004-81-74-A
24
OBSERVATION POSSIBLE CAUSE REMEDY
Ware is coming
out dirty.
1. Improper pre-scapping procedures.
2. Verify the chemical concentrations are
correct.
3. Wash pumps are clogged with debris.
4. Water level is too low and pumps are
cavitating (drawing in air).
5. Strainers are clogged with debris.
6. Pre-wash, wash, or power rinse nozzles are
clogged.
1. Verify proper pre-scrapping procedures are being followed.
2. See the Detergent Control page in this manual. If there
appears to be a problem with the chemicals, contact your
chemical representative.
3. Remove debris if pump is not permanently damaged.
4. Verify water levels are correct by observing whether or not
the “Tank Filled” light is illuminated. If so and problem continues,
visually verify the water level is correct.
5. Remove and clean strainers.
6. Verify nozzles are not clogged with debris. If so, remove
debris.
An excessive
amount of vapor
is exiting the
machine through
the load and/or
unload ends.
1. Exhaust fan is turned off as well as the room
ventilation.
2. Incorrect placement of curtains within the
machine.
3. Water temperatures too hot.
4. Incorrect damper positioning.
1. Ensure the exhaust fan is turned on as well as the room
ventilation.
2. Correct as necessary.
3. Verify water temperatures and ensure they comply with what
is marked on the machine data plate
4. Check correct damper positioning in the electrical section.
Machine
continues to
fill and does
not stop. Green
“Tank Filled”
light does not
come on.
1. No water coming to the machine.
2. Drain valves are open.
3. Water level controls are faulty.
4. Leak in the tank.
5. Drain valve indicates closed but is not.
6. Level control sensors out of adjustment.
1. Verify the power is on and the water supply is also turned on.
2. Verify the position of the valves and shut if necessary.
3. Verify the wiring of the water level controls to the schematic
and if correct, replace.
4. Inspect under the machine to verify there are no holes or
cracks.
5. Replace or repair the drain valve.
6. Level control sensors might need the sensitivity adjusted.
TROUBLESHOOTING
TROUBLESHOOTING
Bekijk gratis de handleiding van Jackson FlightStar, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Jackson |
| Model | FlightStar |
| Categorie | Vaatwasser |
| Taal | Nederlands |
| Grootte | 12592 MB |
