Jackson DynaStar handleiding
Handleiding
Je bekijkt pagina 16 van 86
07610-004-66-53-F
9
Before installing the machine, check packaging and machine for damage. If packaging
is damaged, the machine might also be damaged. If there is damage to both packaging
and machine, do not throw away packaging. The machine has been inspected and
packed at the factory and is expected to arrive in new, undamaged condition. However,
rough handling by carriers or others might result in damage to the machine while in
transit. If so, do not return the machine to the manufacturer; instead, contact the carrier
and ask them to send a representative to the site to inspect the damage and complete
an inspection report. You must contact the carrier and dealer within 48 hours of receiving
the machine.
While removing the machine from packaging, ensure there are no missing parts.
(reference the Parts section). If an item is missing, contact the manufacturer immediately.
The machine must be level in its operating location to prevent
damage during operation and to ensure best results. The
machine comes with four adjustable bullet feet, which can be
turned using a pair of channel locks (or by hand if the machine
can be raised safely). Ensure the machine is level from side-
to-side and front-to-back before making any connections.
Plumbing connections must comply with all applicable local, state, and national plumbing
codes. The plumber must ush incoming water line thoroughly before connecting
plumbing. It is crucial to remove all foreign debris from water line that might potentially
get trapped in valves or cause an obstruction. Any valves that are fouled as a result of
foreign matter left in the water line—and any expenses resulting from this fouling—are
not the responsibility of the manufacturer.
The manufacturer does NOT endorse "Tankless On-demand" water heaters for use
with their dishmachines. The manufacturer DOES endorse, and highly recommends,
standard "Tank" style water heaters, sized to properly handle the water heating
requirements of the facility.
The drain is a gravity-discharge drain. Pitch all piping from the 1 1/2” connection on
wash tank 1/4” per foot to oor or sink drain. All piping from the machine to drain must
be a minimum 1 1/2” and must not be reduced.
There must be an air-gap between the machine drain line and oor sink or drain. The
air-gap must be at least 1.5 times the diameter of drain line. If a grease trap is required
by code, ensure it has a ow capacity of 5 GPM.
INSPECTION
LEVELING
UNPACKING
PLUMBING
DRAIN LINE
CONNECTION
Do not throw away the
container if damage is
evident!
The plumber must ush
the incoming water line!
INSTRUCTIONS
INSTALLATION
Check for missing parts!
Machine must be level
before operating!
Bekijk gratis de handleiding van Jackson DynaStar, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Jackson |
| Model | DynaStar |
| Categorie | Vaatwasser |
| Taal | Nederlands |
| Grootte | 12043 MB |
