Jackson DishStar HT-E handleiding
Handleiding
Je bekijkt pagina 12 van 54
5
07610-004-43-79-D
INSTRUCTIONS
INSTALLATION
WATER SUPPLY
CONNECTIONS:
WATER HARDNESS
HIGHER THAN
5 GPG
Before installing the machine, check packaging and machine for damage. Damaged
packaging might be an indication of damage to the machine. If there is any type of
damage to both packaging and unit, do not throw away the packaging. The machine
has been inspected at the factory before shipping and is expected to arrive in new,
undamaged condition. However, rough handling by carriers or others might result in
damage to the machine while in transit. If this occurs, do not return the machine to
the manufacturer. Instead, contact the carrier and ask them to send a representative
to the site to inspect the damage and request that an inspection report be completed.
Contact the carrier within 48 hours of receiving the machine as well as the dealer that
sold you the machine.
The machine should be unboxed and removed from the pallet before installing. Open
the front door and remove all materials from inside. Once unpacked, verify there are no
missing parts. If a part is missing, contact the manufacturer immediately.
All plumbing connections must be made to adhere to local, state, territorial, and
national codes. The installing plumber is responsible for ensuring the incoming
water lines are ushed of debris before connecting to the machine. Note that chips
and materials from cutting processes can become lodged in the solenoid valves
and prevent them from opening or closing. Any valves that are found to be fouled
or defective because of foreign matter left in the water line, and any subsequent
damage, are not the responsibility of the manufacturer.
A water hardness test must be performed. A hardness test kit can be found on the
warning tag that is attached to the incoming plumbing connection on the back of the
machine. If water hardness is higher than 5 GPG, install a water softener or install the
optional HTS-11 (scale prevention and corrosion control). See the Plumbing Options
page for more information on the HTS-11.
If water hardness is higher than 5 GPG and a water softener is not being used, install
the HTS-11 into the water line (1/2” ID pipe size minimum) before the machine’s
incoming water connection point using copper pipe. Observe proper inlet/outlet water
directions (ow directions are molded into the top of the head). It is recommended
that a water shut-o valve be installed before installing the HTS-11 to allow access for
service. Plumb from the HTS-11 outlet to the incoming water connection point using
copper pipe (or order the 1/2” ID exible hose kit oered by manufacturer). The water
supply must be capable of a minimum of 10 PSI “ow” pressure at the recommended
temperature indicated on the data plate. See the Plumbing Options page for more
information on the HTS-11.
INSPECTION
Do not throw away
packaging if damage is
evident!
UNPACKING
PLUMBING
A water hardness test
must be performed.
The plumber must ush
the incoming water line!
Bekijk gratis de handleiding van Jackson DishStar HT-E, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Jackson |
| Model | DishStar HT-E |
| Categorie | Vaatwasser |
| Taal | Nederlands |
| Grootte | 8316 MB |
