Inventum VKI3020ZWA handleiding

40 pagina's
PDF beschikbaar

Handleiding

Je bekijkt pagina 18 van 40
18 English
cleaning and maintaining the induction hob
6
DAILY CLEANING
Warning: Allow all cooking zones to cool down before cleaning the induction hob and activate the child lock before
youbegin.
Warning: When spilling sugar, immediately clean the hob to prevent the sugar from burning into the surface.
Be careful, the cooking zones can be hot.
Careful: Do not use abrasive cleaning agents, aerosols, abrasive sponges or sharp objects that have not been
developed for this purpose
1. Lock the cooking zones.
2. Remove spilled food. Use a damp cloth and a mild cleaning agent.
3. Clean the appliance daily. Use a damp cloth and a mild cleaning agent.
4. Dry the appliance Use kitchen towel for this or a dry tea towel.
5. In case of severe contamination, clean the appliance with a cleaning agent that is specifically suitable for an induction
appliance.
6. When food has been spilled on the control elements, the appliance may give a beep sound and switch off automatically.
installation instructions
7
Safety during use is only guaranteed if the assembly has taken place in a technically correct way and in accordance
withthese installation instructions.
The hob must be connected to a permanent installation in which provisions for switching off are integrated,
inaccordance with the installation instructions.
Make sure that the power supply cable does not get jammed during installation or is running along sharp edges.
It must be placed in such a way that no contact is made with hot parts of the induction hob.
The connection point, socket and/or plug must always be accessible.
The worktop on which the cooker is placed must be flat, horizontal and stable.
In case of incorrect installation or connection, the warranty becomes invalid.
• Attention: any change within the appliance, including replacement of the power supply cable, must be performed
byanauthorised installer.
Sufficient space around the cooker is required for safe use. Check that this space is available.
The distance from the cooker to an extraction hood should be at least 650 mm.
ELECTRICAL CONNECTION
Caution: this cooker is always supplied with a cord and plug. The connection is a 1 phase connection.
Check that the voltage corresponds with what is stated on the information plate.
Caution: The connection point should always be within reach.
breakdowns & solutions
8
GENERAL PROCEDURE FOR TROUBLESHOOTING
1. Use the troubleshooting table and breakdown codes to find a solution for the problem.
2. If you cannot find a solution, or if the breakdown code keeps returning, contact the Inventum service department.
Breakdown (code) Cause What to do
The induction hob does not function,
even though the plug is inserted
inthesocket.
No power supply. Check that the plug is properly
inserted in the socket and that
thereispower on the socket.
The hob cannot be activated.
The control panel is locked
by means of the child lock.
Unlock the control panel. See section
'Key lock.
The control panel is dirty or covered
witha thin film of water.
Clean the appliance. See section
'Dailycleaning'.
The induction hob stops all ofasudden
during use and thedisplayshows
.
An unsuitable pan is being used.
Use a pan suitable for induction with the
correct diameter (minimum Ø 14 cm).
The diameter of the pan used is
toosmall.

Bekijk gratis de handleiding van Inventum VKI3020ZWA, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.

Productinformatie

MerkInventum
ModelVKI3020ZWA
CategorieNiet gecategoriseerd
TaalNederlands
Grootte3860 MB