Intermatic PE953 handleiding
Handleiding
Je bekijkt pagina 36 van 51
36 Multi-Wave PE953 Installation Guide
Copyright © 2011 Intermatic, Inc.
6. Now press the button on a device that will be
controlled as part of the association. The screen
displaysSETDEVICELEVELTHENPRESS1TO
ADD THEDEVICETOTHEASSOCIATION.
7. Set the device to what you want “ON” to be
for the item being controlled. There are circum-
stances where you may want to turn some lights off and others ON
when the scene is activated, so set accordingly.
NOTE:
If controlling a light on a dimmer switch, preset the
dimmer level to the desired brightness at this time.
8. Press button <1> as instructed. The screen adds the word SUCCESSFUL.
The device is now included in the association. An association now
exists between the association-capable device and devices in the
association (including the PE653 if it is included in the association.)
NOTE:
Only circuit 1 of the PE653 can be controlled via
association.
Repeat as necessary to add other devices to the association.
9. Press the <ENTER> button if you wish to return to the Main screen.
10. Youcannowcontrolallthedevicesintheassociationwiththeassocia
tion-capablecontroller.Youdon’tneedthehandheld.
Section 5:
Using the PE953 with the PE650
Receiving Device
It’spossibletocontrolaPE650networkwiththenewer,moreadvanced
PE953 Hand-Held Controller Control.
Linking the PE953 Hand-Held Controller with the PE650
Receiving Device
This procedure creates a network between the Hand-Held Controller and the
PE650 Receiving Device, making it possible to complete the rest of the setup
procedure and operate the system.
NOTE: If the word FAILURE instead of SUCCESSFUL appears at the bottom
of the screen during any of the following steps, repeat the programming
procedure, then try replacing the batteries in the Hand-Held. If the
problem persists, contact Intermatic Customer Service.
1. Ifnecessary,pressandreleaseanybuttononthe
Hand-Held Controller to wake it from sleep. If the
screen is not displaying LEARN MODE, press and
hold the <P/S> and <ENTER> buttons at the same
time to put the device into programming mode. You
are in programming mode when the LEARN MODE
screen is displayed, as shown at the right.
2. Press and release the <3> function button to select
INCLUDE DEVICE. The screen refreshes with
instructionstoPRESSBUTTONONDEVICETO
INCLUDE,asshown.
3. Press the black button on the base of the antenna of the PE650.
Iftheactionissuccessful,thescreendisplaysthewordSUCCESSFUL,as
shown, then returns to the LEARN MODE screen.
NOTE: If the two devices are not successfully linked
and you are seeing the word FAILURE at the bottom
of the screen, carefully repeat the procedure. If
the problem persists, contact Intermatic Customer
Service.
4. Press the <ENTER> button if you wish to return to the Main screen.
ThecircuitswiredinthePE650network(uptove)cannowbecontrolled
ON/OFFwiththevefunctionbuttonsonthePE953Hand-HeldController.
Bekijk gratis de handleiding van Intermatic PE953, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Intermatic |
| Model | PE953 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 8177 MB |
