Intergas Xtend Split handleiding
Handleiding
Je bekijkt pagina 71 van 88
71
Parameter Category Setting
Default
value Description/Setting range
P202P202
CH comfort Setting thermostat control 4
0 = Full control by WDC. None
thermostat connected.
1 = WDC + room temp. compensation control.
2 = WDC + room temp. compensation control.
+ ON/OFF thermostat.
3 = WDC + ON/OFF thermostat.
4 = Standard OpenTherm thermostat.
5 = WDC + ON/OFF thermostat (via
OpenTherm or ON/OFF shortcut).
6 = Fixed water temperature + ON/OFF
thermostat.
7 = Internal WDC + external OpenTherm
thermostat.
8 = WDC + ON/OFF thermostat (proportional
band).
P203P203
CH comfort Setting thermostat hysteresis. 0.50 0.00 to 2.50 (increments of 0.01)
P206P206
CH comfort
Setting nightly reduction and/or daily
increase (ΔT); see §11.5
1.0 0.0 to 5.0ºC (increments of 0.1)
P207P207
CH comfort
Activating/deactivating room heating
modes.
1
0 = o
1 = on
P209P209
CH comfort
Influencing the thermostat based on
the heating curve (if P202 = 7)
(0% = no influence).
50 0 to 100%.
P210P210
CH comfort Raising/lowering the heating curve. 0 -5 ºC to 40 ºC.
P211P211
CH comfort Slow-start setting (0 = o). 60 0 to 240 min.
P214P214
CH comfort
Setting the hour of the day that the
maximum temperature is reached (if
P180=1 Eco mode = ON).
16 0 to 23 hours.
P216P216
CH comfort
Setting external temperature.
(Deactivates nightly reduction and
daily increase at this value).
-10 ºC -20 ºC to 20 ºC.
P217P217
CH comfort
Setting a value for immediately
switchen the CH-boiler when the
room thermostat temperature is set
manually (0 = o)
0,7 0,0 t/m 5,0ºC
P218P218
CH comfort
Defines a "lower temperature". It
blocks the CH-boiler if the room
temperature deviation is smaller than
P219. See §11.4.1 (10 = o)
10 10 to 20 ºC
P219P219
CH comfort
Setting maximum drop (regarding
P218).
0.5 0.0 to 5.0 ºC
P220P220
CH comfort
Setting the desired compressor ‘ON’
time (if P202=5).
90 15 to 240 min.
P221P221
CH comfort
Setting maximum deviation as a result
of the adaptive ON/OFF control based
on the heating curve (if P202=5 or 8).
3.0 0.0 to 10.0 ºC
P255P255
General Reset the device to factory settings 0
0 = o
9 = reset to factory settings
Bekijk gratis de handleiding van Intergas Xtend Split, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Intergas |
| Model | Xtend Split |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 11570 MB |
