Infiniton CAS2OV50D handleiding
Handleiding
Je bekijkt pagina 17 van 37
17 inniton.es
Installation
English
PIPING CONNECTION
1. Pipe sizes should be G1/2”; Maximum inlet pressure should be expressed in Pa; Minimum inlet pressu-
re should be expressed in Pa.
2. Connection of the pressure relief valve with the heater at the inlet of the water heater.
3. To avoid leakage when connecting the pipes, the rubber sealing gaskets supplied with the heater
should be added at the end of the threads to ensure leak-proof joints (see Fig.4).
4. If you wish to make a multi-outlet supply system, refer to the method shown in Figures 5 and 6 to
connect the piping.
Be sure to use the accessories supplied by our company to install this electric water heater. This
electric water heater cannot be hung on the bracket until it has been conrmed to be rm and relia-
ble. Otherwise, the electric water heater may fall off the wall, which may cause damage to the heater,
including serious injury accidents. When determining the location of the bolt holes, you should ensure
that there is a clearance of not less than 0.2 m on the right side of the electric water heater to facilitate
maintenance of the heater, if necessary.
A Hot water outlet
B Rubber gaskets
C Screw for hot water outlet
D Mixing valve adjustment lever
E Cold water inlet
F Rubber gaskets
G Pressure relief valve
H Pressure relief orice
I Union screw for cold water inlet
J Shower outlet
K Power cable
A Hot water outlet
B Cold water inlet
C Triple seal
D Water tank
E Mixing valve
F Power cable
G Main unit
H Pressure relief valve
I Water inlet valve
J Shower outlet
K Water inlet valve
L Running water pipe
Bekijk gratis de handleiding van Infiniton CAS2OV50D, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Infiniton |
| Model | CAS2OV50D |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3905 MB |
