Indesit Push&Go IN2FE13DT9WUK handleiding

Vaatwasser

Indesit

50 pagina's

PDF beschikbaar

Handleiding

EN / 17

Setting the water softening system

Washing efficiency will be improved when

the water softening system is set correctly.

Read the section on adjusting the water

softening system first.

Regeneration of the water softening sys-

tem can take place in all cycles during the

drying step. When regeneration is per-

formed, the duration of the cycle, energy

and water consumption are increased.

For the regeneration process, the table

below shows the frequency of the

regeneration process, maximum additional

time, water and energy consumption

depending on the water consumption for

the Eco 50 °C cycle when the dishwasher is

operated under standard conditions with a

water supply of 14 dH.

Eco 50 °C

water consumption (l)

renew after .... cycle Additional time (min)

Additional water con-

sumption (l)

Additional energy

consumption (kWh)

12.3-14.7 5 5 3.0 0.05

9.6-12.2 6 5 3.0 0.05

9.0-9.5 7 5 3.0 0.05

8.0-9.0 8 5 3.0 0.05

7.0-7.9 9 5 3.0 0.05

For water consumption in the Eco 50 °C

cycle of your dishwasher, refer to the Cycle

Information and Average Consumption Val-

ues Table given in the Cycle Table.

6.3 Setting the Water Softening

System

Setting the water softening system cor-

rectly will improve your dishwasher’s wash-

ing, rinsing, and drying performance.

NOTICE! To set the system, first find out

your water hardness level from the au-

thorised service in your region and set it

as follows.

After determining the water hardness:

1. While the Program Selection Knob is

“Off”, press and hold the Start / Hold / Can-

cel key and rotate the Program Selection

Knob one step clockwise and keep the

Start / Hold / Cancel key pressed for 3

seconds; the dishwasher shall switch to re-

generation setting mode after this period.

2. The regeneration level in the memory is

illuminated for 5 seconds when you enter

the regeneration setting mode.

3. For setting a new Water Hardness Level,

bring the Program Selection Knob to the

proper position for the hardness level of

your mains water. (See Water Hardness

Level Setting Table)

4. Press the Start / Hold / Cancel key to re-

cord the selected setting in the memory.

5. Bring the Program selection knob to “Off”

position.

Bekijk gratis de handleiding van Indesit Push&Go IN2FE13DT9WUK, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.