Handleiding
Je bekijkt pagina 7 van 24
07
Positioning the Cooker
Study the diagrams below to be sure of the dimensions
required to locate the cooker safely. Make sure that the
top of the cooker is at least 10mm higher than the level of
the bench tops. The appliance has been designed to fit in a
550mm wide gap in kitchen cabinets. The cooker may also
be installed at the end of a line of benches or with a free
space on either side.
Levelling feet
The height and level of the appliance can be adjusted
by rotating the feet located underneath the appliance
at each corner. Rotate the feet to decrease or increase
the height.
Safety chain
The appliance must be secured against overbalancing by
using the supplied two safety chains on your oven.
Fasten hook (1) by using a proper peg to the kitchen wall
(5) and connect safety chain (3)to the hook via the locking
mechanism(2).
1. Safety chain(supplied and mounted to oven)
2. Stability hook
3. Firmly fix chain to cooker rear
4. Rear of cooker
5. Kitchen wall
Mounting or Replacing the Power Cord
Warning! Connect the power cord must be in accordance
with the instructions listed in the table below.
Wire cross sectional area (mm)
L1 N E
Connection
Mode
1N~ Min 4 Min 4 Min 4
2N~ Min 2.5 Min 4 Min 4
3N~ Min 1.5 Min 4 Min 4
Installation Instructions (Continued)
Warning! Connect the power cord must be in accordance with the instructions listed in the table below.
Wire cross-sectional
area (mm2)
Connection Mode
L1 L2 L3 N E
1N~ Min 4 - - Min 4 Min 4
2N~ Min 2.5 Min 2.5 - Min 4 Min 4
3N~ Min 1.5 Min 2.5 Min 2.5 Min 4 Min 4
Connecting the supply cable to the mains
Install an approved circuit breaker with a minimum contact opening of 3 mm, between the appliance and the
mains fuse box. The circuit breaker should be sized according to the load and should comply with current
regulations (the earth wire should not be interrupted by the circuit breaker).
The supply cable should be positioned so that it does not reach a temperature of more than 50ºC above
ambient temperature (or room temperature), anywhere along its length.
Before switching the fuse ON within the meter-box, please check:
• Earth continuity. The electrical safety of thi
s appliance can only be guaranteed if the cooker is correctly
installed and earthed, in compliance with regulations on electrical installations.
• The electrical capacity of the system and sockets will support the maximum power of the appliance, as
indicated on the data plate.
Locating the cooker
Study the diagrams below to be sure of the dimensions required to locate the cooker safely. Make sure
that the top of the cooker is at least 10mm higher than the level of the bench tops. The appliance has been
of benches or with a free space on either side.
Levelling feet
The height and level of the appliance can be adjusted by rotating the feet located underneath the appliance at
each corner. Rotate the feet to decrease or increase the height.
Installation Cont.
Bekijk gratis de handleiding van InAlto I54OSEW, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | InAlto |
| Model | I54OSEW |
| Categorie | Fornuis |
| Taal | Nederlands |
| Grootte | 2308 MB |
