Handleiding
Je bekijkt pagina 6 van 24

06
Prior to Beginning Installation
• Make sure to check the condition of the appliance after
unpacking it. Do not continue with installation if it has
been damaged during transport.
• Safe operation of this appliance can only guaranteed
if it has been professionally assembled and installed
in accordance with these instructions by a qualified
technician. The individual who assembled and installed
the appliance is liable for damages or faults resulting
from an incorrect assembly or installation.
• Installation and maintenance must be carried out by an
authorised service agent or similarly qualified technician.
• Ensure power to the appliance has been shut o before
carrying out any installation or maintenance.
• It is vital that the appliance is properly earthed before
completing the installation process.
• If a rangehood is to be fitted, follow the installation
guidelines supplied with the rangehood.
General Installation Warnings
• The appliance must be installed by a licensed electrician.
• Please never try to modify or repair the appliance
by yourself.
• The appliance should be installed
with adequate ventilation.
• A certificate of compliance must be supplied by the
Installer and is to be kept by the customer.
• The packing materials must be removed before
you install the cooker.
• You must follow the installation instructions
in this user manual.
• The surrounding kitchen cabinets must be able to
withstand 85ºC.
• The appliance must not be installed in a corner. It must
be installed at least 100mm from the side wall.
• Do not obstruct the vents, openings and air spaces
on the appliance.
• The anti-tilt plate must be installed
to avoid accidental tipping.
• The stabilising bolt must be installed to avoid
accidental moving.
• You must not pull or lift the appliance
by the door handles.
• A suitable isolating switch providing full disconnection
from the mains power supply must be incorporated in
the permanent wiring. The switch must be mounted
and positioned to comply with the local wiring rules and
regulations. The isolating switch must be of an approved
type and provide a 3 mm air gap contact separation in
all poles (or in all active [phase] conductors if the local
wiring rules allow for this variation of the requirements).
The isolating switch will be easily accessible to the
customer with the oven installed.
• If the supply cord or cable is damaged, it must be
replaced by an approved service agent or a similarly
qualified person in order to avoid a hazard.
• According to the electrical safety regulations, the
appliance must be properly earthed.
Connection of the Appliance
Connecting the appropriate power supply
(terminal board/connector block)
• Using a screwdriver, prize open tabs of the Terminal
board cover.
• Remove the wire clamp screw.
• Fasten the wires beneath the corresponding screw heads,
using brass ‘bridge’ for single phase supply.
• Fasten cable clamp and close the cover of the
terminal board.
• The AC power supply should be 220-240 V, 50/60 Hz. The
minimum 45A fuse, or at least 45A a distribution circuit
breaker.
Connecting the supply cable to the mains
Install an approved circuit breaker with a minimum contact
opening of 3 mm, between the appliance and the mains
fuse box. The circuit breaker should be sized according to
the load and should comply with current regulations (the
earth wire should not be interrupted by the circuit breaker).
The supply cable should be positioned so that it does not
reach a temperature of more than 50ºC above ambient
temperature (or room temperature), anywhere along its
length. Before switching the fuse ON within the meter-box,
please check:
• Earth continuity. The electrical safety of this appliance
can only be guaranteed if the cooker is correctly installed
and earthed, in compliance with regulations on electrical
installations.
• The electrical capacity of the system and sockets will
support the maximum power of the appliance,
as indicated on the data plate.
Installation Instructions
Bekijk gratis de handleiding van InAlto I54OSEW, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
Merk | InAlto |
Model | I54OSEW |
Categorie | Fornuis |
Taal | Nederlands |
Grootte | 2308 MB |