IKEA LAGAN 705.680.13 handleiding

44 pagina's
PDF beschikbaar

Handleiding

Je bekijkt pagina 13 van 44
13ENGLISH
What to do if ...
In case your dishwasher doesn’t work properly, check if the problem can be solved by going through the following
list. For other errors or issues please contact authorized After-sales Service which contact details can be found in
the guarantee booklet. Spare parts will be available for a period of either up to 7 or up to 10 years, according to the
specic Regulation requirements.
The spare parts can be found: https://parts-selfservice.whirlpool.com/en/landing
Problems... Possible causes... Solutions...
Salt indicator
is lit
Salt reservoir is empty. (After rell the salt
indicator may remain lit for several wash
cycles).
Rell reservoir with salt (for more information - see page 7).
Adjust water hardness - see table, page 8.
The dishwasher
won’t start or
does not respond
to commands.
The appliance has not been plugged in
properly.
Insert the plug into the socket.
Power outage.
For safety reasons, dishwasher will not re-start automatically when
power returns. Open dishwasher door, press START/Pause button
and close the door within 4 seconds.
The dishwasher door is not closed. Vigorously push the door until you hear the “click”.
Cycle is interupted by door opening for
more than 4 seconds.
Press START/Pause and close the door within 4 seconds.
It does not respond to commands.
Switch o the appliance by pressing the ON/OFF button, switch it
back on after approximately one minute and restart the program.
If problem persists, unplug the appliance for 1 minute, then plug it
back in.
The dishwasher
won’t drain.
The wash cycle has not nished yet. Wait until the wash cycle nishes.
The drain hose is bent. Check that the drain hose is not bent (see INSTALLATION).
The sink drain pipe is blocked. Clean the sink drain pipe.
The lter is clogged up with food residues. Clean the lter (see CLEANING THE FILTER ASSEMBLY).
The dishwasher
makes excessive
noise.
The dishes are rattling against each Position the crockery correctly (see LOADING THE RACKS).
An excessive amount of foam has been
produced.
The detergent has not been measured out correctly or it is not
suitable for use in dishwashers (see FILLING THE DETERGENT
DISPENSER). Restart the current cycle by switching OFF the
dishwasher, then switch it on again, select a new program, press
START/Pause and close the door within 4 seconds. Please do not
add any detergent.
The dishes are
not clean.
The crockery has not been arranged
properly.
Arrange the crockery correctly (see LOADING THE RACKS).
The spray arms cannot rotate freely, being
hindered by the dishes.
Arrange the crockery correctly (see LOADING THE RACKS).
The wash cycle is too gentle and/or
detergent eciency is low.
Select an appropriate wash cycle (see PROGRAMS TABLE).
An excessive amount of foam has been
produced.
The detergent has not been measured out correctly or it is not suita-
ble for use in dishwashers (see FILLING THE DETERGENT DISPENSER).
The cap on the rinse aid compartment has
not been shut correctly.
Make sure the cap of the rinse aid dispenser is closed.
The lter is soiled or clogged. Clean the lter assembly (see CLEANING AND MAINTENANCE).
There is no salt. Fill the salt reservoir (see FILLING THE SALT RESERVOIR).
Dishwasher
nishes the cycle
prematurely.
Drain hose positioned too low or siphoning
into home sewage system.
Check if end of drain hose is placed at correct height (see
INSTALLATION). Check for siphoning into home sewage system,
install air admittance valve if necessary.
Air in water supply. Check water supply for leaks or other issues letting air inside.
The dishwasher
does not ll the
water.
All LEDs are
blinking rapidly
No water in the water supply or the tap is
closed.
Make sure there is water in the water supply or the tap running.
The inlet hose is bent.
Make sure the inlet hose is not bent (see INSTALLATION) reprogram
the dishwasher and reboot.
The sieve in the water inlet hose is clogged;
it is necessary to clean it
After having carried out the verication and cleaning, turn o and
turn on the dishwasher and restart a new program.

Bekijk gratis de handleiding van IKEA LAGAN 705.680.13, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.

Productinformatie

MerkIKEA
ModelLAGAN 705.680.13
CategorieVaatwasser
TaalNederlands
Grootte9023 MB