IFM TAD181 handleiding
Handleiding
Je bekijkt pagina 19 van 22
19
UK
FOU2 Response of the analogue signal when a diagnostic case is signalled:
> Instead of the measured temperature value a defined current value according
to Namur NE43 is provided (On: 21�5 mA; OFF: 3�5 mA)
dOU1 Response of the diagnostic switching output when a diagnostic case is signalled:
> Output opens / closes / pulsates depending on the category of the diagnostic
case�
Setting options see Table 4 → 5.3.5
P-n Switching logic for the diagnostic switching output: pnp or npn�
HI Read max� value of the temperature measured in the process�
LO Read min� value of the temperature measured in the process�
Fnr Read fault number → 11 Fault correction�
rES Restoring the factory settings�
It is recommended to note down your own settings before carrying out a
reset (→ 12 Factory setting)�
9 Operation
When the supply voltage is applied, the unit is in the RUN mode after a power-on
delay time of 8 s (= normal operating mode)� It carries out its measurement and
evaluation functions and provides output signals according to the set parameters�
10 Technical data
Technical data and scale drawing at www�ifm�com�
10.1 Setting range for drW / drA
Medium temperature Setting range
-10���100 °C 14���212 °F 0�2���5 K
-25���0 °C -13���32 °F 0�3���5 K
> 100 °C > 212 °F x...5 K (→ chart)
Bekijk gratis de handleiding van IFM TAD181, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | IFM |
| Model | TAD181 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 1559 MB |
