IFM RM901S handleiding
Handleiding
Je bekijkt pagina 15 van 26
Encoder (SR) with CANopen interface RM900S RM901S RM902S RM903S
15
u Observe the environmental conditions, the shaft load and the permissible axial and radial shaft
movement tolerances specified in the part number-specific data sheet.
u Installation in idle state without mains connection
u Slide the encoder (SR) onto the drive shaft.
u Fasten all three wings of the torque support to the machine using two M3 cylinder head screws,
each in combination with suitable washers.
• Do not warp or prestress the plates.
• The screw connections must be secured with medium-strength screw retaining compound to
prevent unintentional loosening.
• The nominal tightening torque for M3 standard threads applies depending on the strength class of
the screw, with a minimum tightening torque of 0.5 Nm.
u Fasten the clamping ring to the drive shaft with the clamping ring screw (tightening torque 2 Nm).
u Do not warp or prestress the torque support.
u Do not reuse improperly fitted or damaged torque supports.
u Observe the mounting instructions for mounting the clamping ring → Chapter “Mounting the
clamping ring”.
The torque support is corrosion-resistant in an industrial atmosphere. Clarify special environmental
conditions / media with ifm electronic.
1
2
3
4
1: Clamping ring
2: Flange plate (machine)
3: Parallel key
4: Actuator shaft
6.4 Lubricity
Regular movement of the shaft preserves lubricity during service life.
w Long-term storage reduces lubricity.
Bekijk gratis de handleiding van IFM RM901S, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | IFM |
| Model | RM901S |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 1878 MB |
