IFM DW3003 handleiding
Handleiding
Je bekijkt pagina 31 van 32
Evaluation unit for monitoring and converting frequency signals DW3003
31
10 Troubleshooting
Display LED / process data bit Error Troubleshooting
[SC-1] Status: red (flashes at 1 Hz)
Output 1: yellow (flashes at 4 Hz)
Short circuit / overload at digital
output 1.
Remove short circuit / overload at digital
output OUT1.
[SC-2] Status: red (flashes at 1 Hz)
Output 2: yellow (flashes at 4 Hz)
Short circuit / overload at digital
output 2.
Remove short circuit / overload at digital
output OUT2.
[SC-3] Status: red (flashes at 1 Hz) Short circuit / overload at ana-
logue output (only for voltage
output).
Remove short circuit / overload at ana-
logue output OUT3.
[SC-SS] Status: red (flashes at 1 Hz) Short circuit / overload at sensor
supply.
Remove short circuit / overload at sen-
sor supply +.
[OL] Status: red (flashes at 1 Hz)
Input 1: off
Fault In1: high
Frequency at input 1 above
measuring range.
Signal at analogue output above
operating range.
Check input signal.
Check analogue output parameters.
[UL] Status: red (flashes at 1 Hz)
Input 1: off
Fault In1: high
Signal at analogue output below
operating range.
Check analogue output parameters.
[Warn] Status: red (flashes at 1 Hz) Load for analogue output too
high (only for current output).
Check load.
[PARA] Status: red (flashes at 1 Hz) Invalid parameter set. Check parameter settings.
[Err] Status: red (flashes at 1 Hz)
Output 1: off
Output 2: off
Device temperature too high. Reduce device temperature.
Status: red (flashes at 1 Hz)
Status: red Device faulty. Replace the device.
Status: off Supply voltage too low. Check/correct supply voltage.
Status: double flashing
Input 1: double flashing
Restart 1: double flashing
Reset 1/2: double flashing
: double flashing
Output 1: double flashing
Output 2: double flashing
Locator Start activated. Deactivate locator.
[Loc] Parameter setting via pushbut-
tons disabled.
Unlock pushbuttons:
Locking / unlocking (Ò/22)
[C.Loc] Parameter setting via pushbut-
tons locked due to active IO-Link
parameter setting.
Wait until parameter setting via IO-Link
is finished.
[S.Loc] Parameter setting via pushbut-
tons disabled by software.
Unlocking only possible via IO-Link in-
terface/IO-Link parameter setting soft-
ware.
LEDs or process data bits that are not listed can exhibit any behaviour.
Bekijk gratis de handleiding van IFM DW3003, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | IFM |
| Model | DW3003 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 2679 MB |
