IFM AL1433 handleiding
Handleiding
Je bekijkt pagina 15 van 86
IO-Link master with EtherCAT interface AL1433
15
u Optional: Connect pin 5 of port XD1 or XD2 via an L-coded M12 connector to the FE socket of the
power supply.
6.7 Voltage supply
The device is connected to the supply voltage US via port XD1.
The supply voltage US supplies the device and the devices connected to ports X1...X8 with voltage.
Optionally, an additional supply voltage UA can be fed to the device via port XD1.
CAUTION
Exceeding the maximum input current of 16A
w Risk of fire
u Dimension the IU and IA of the supply sources US and UA, taking into account the
derating behaviour of the device: Derating behaviour (Ò/15)
ATTENTION
The supply voltages US and UA are not protected against cross polarity.
w Damage to the device
u Ensure correct connection of the supply voltages US and UA.
u In case of cables that are longer than 25m, take the voltage drop and the necessary
minimum supply voltage of 20 V into consideration!
Port XD1 is equipped with overvoltage protection (US).
Port XD1 is equipped with reverse polarity protection (US, UA).
Wiring:
3
1 4
2
5
1: +24V DC (US)
2: GND (UA)
3: GND (US)
4: +24V DC (UA)
5: FE
u Disconnect power.
u Connect the device via port XD1 to the supply voltage US with 24VDC (20...30 V SELV/PELV;
according to IEC 61010-1, secondary circuit with max. 30 V DC, supplied from main circuit up to
300 V of overvoltage category II).
u Optional: Connect the device via port XD1 to the supply voltage UA with 24VDC (20...30 V SELV/
PELV; according to IEC 61010-1, secondary circuit with max. 30 V DC, supplied from main circuit
up to 300 V of overvoltage category II).
u For connection, use an L-coded M12 connector (minimum protection rating: IP 65 / IP 66 / IP 67 /
IP 69K).
u Tighten the cable sockets according to the torque specifications indicated by the cable vendor.
Maximum permissible tightening torque: 0.8Nm
6.7.1 Derating behaviour
The current intensity I
US
available at ports X1...X8 and the current intensity I
US-daisy-chain
and the current
intensity I
UA-daisy-chain
available on port XD2 depend on the ambient temperature of the device.
The derating measurements were carried out under the following conditions: Supply voltage
US / UA: 24VDC
Bekijk gratis de handleiding van IFM AL1433, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | IFM |
| Model | AL1433 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 7147 MB |
