IDIS DP-DD1316 handleiding
Handleiding
Je bekijkt pagina 12 van 33
12
Part 1 - Introduction
Rear Panel Connections
Monitor Connection
Connect to the VGA OUT or HDMI port.
1 2
3 4
Video Connection
●
Video In/PoE
Connect switch or the NVR using RJ-45 cable (Cat5, Cat5e,
or Cat6).
• Green LED on the right will turn on when PoE
comes on line. Orange LED on the left will then
ash once a link has been established.
• If more than 16 cameras from video encoders are
registered on the NVR, video may not be displayed
smoothly in a remote program.
Power Cable Connection
This video decoder does not feature a separate power on/
o button and will turn on the moment power is supplied.
Connect the connector(12V) of adapter to the video
decoder and then connect the AC power cable of adapter
to the power outlet.
Factory Reset
Located next to the Power LED port on the front of the
video decoder is a switch that, once activated, will reset
the video decoder to all its initial factory settings.
A factory reset will clear all video decoder settings
congured by the user.
You will need a straightened paper clip to access the
factory reset button.
1
Turn o the video decoder.
2
Insert a straightened paper clip into the factory reset
switch hole and press the switch. Turn on the video
decoder while holding the switch.
3
Press and hold until you hear 2 beeps from the video
decoder’s internal buzzer.
4
All video decoder settings will be returned to their
factory values once you remove the paper clip.
Bekijk gratis de handleiding van IDIS DP-DD1316, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | IDIS |
| Model | DP-DD1316 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 2579 MB |
