Icom IC-T10 handleiding
Handleiding
Je bekijkt pagina 19 van 48
4
REPEATER AND DUPLEX OPERATION
4-2
A Repeater receives signals on one frequency, and
then retransmits them on a dierent frequency.
When using a Repeater, the transmit frequency is
shifted from the receive frequency by a frequency
oset.
A Repeater can be accessed using the Duplex
function by setting the transceiver’s oset to the same
value as the Repeater’s oset.
Accessing a repeater
Station A:
Uplink: 145�500 MHz
Downlink: 144�900 MHz
Repeater
Station B:
Uplink: 145�500 MHz
Downlink: 144�900 MHz
Step 1. Setting the Repeater frequency
1� Repeatedly push [V/M/C] to select the VFO mode�
2� Rotate [DIAL] to set the repeater output frequency�
TIP: For only the USA version
Steps 3 to 5 are not necessary if the Auto
Repeater function (p� 5-7) is turned ON since
the function automatically sets the repeater
settings�
3� Set the repeater tone in the Set mode (p� 5-3)�
4� Set the duplex direction in the Set mode (p� 5-4)�
5� Set the offset frequency in the Set mode (p� 5-4)�
Step 2. Transmitting
1� Hold down [PTT] for 2 seconds�
• If your transmit signal reached the repeater, after
releasing [PTT], you can hear the repeater’s call sign
in morse codes or its announcement�
▲
Accessing
a Repeater
Receiving from
a Repeater
Hold down [PTT] for
2 seconds�
Receives the
Repeater’s call sign�
2� Operate in the same way as a simplex call,
alternately transmit and receive�
Receive frequency
Transmit frequency
Shifts by the oset amount
Bekijk gratis de handleiding van Icom IC-T10, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Icom |
| Model | IC-T10 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 4629 MB |
