Icom IC-T10 handleiding
Handleiding
Je bekijkt pagina 16 van 48
3
SCAN OPERATION
3-4
VFO Scan
The VFO scan searches for signals within the
specied frequency range.
1� Repeatedly push [V/M/C] to select the VFO mode�
2� Hold down [SCAN] until a beep sounds to start
the scan�
L While scanning, repeatedly push [SET] to select a
scan type�
Full scan
Band scan
Program scan
L While scanning, the scan type in progress is
indicated by two letters�
L While scanning, push [BAND] to change the band to
scan, or scope of the Program Scan�
L While receiving a signal, the S-meter displays the
received signal strength�
3� Push [SCAN] or [V/M/C] to cancel the scan�
TIP:
• While scanning, rotate [DIAL] to change the
scanning direction�
• While scanning, hold down [ ] to turn the Lock
function ON or OFF�
D VFO Scan type
There are the following types of VFO scans�
ALL: Full scan
bAnd: Band scan
PROG1 ~ 3: Program scan
TIP: About the Band scan
While scanning the VHF or UHF band, push [BAND] to
switch the scan to the other band�
L While scanning the FM radio band, you cannot switch to
VHF or UHF�
D Using the Program Skip function
You can skip unnecessary frequencies during a scan�
Enter the Skip Channel in Memory mode to use the
function�
L The skipped frequencies will be scanned if the Program
Skip function is turned OFF in the Set mode (p� 5-4)�
Bekijk gratis de handleiding van Icom IC-T10, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Icom |
| Model | IC-T10 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 4629 MB |
