Icom IC-FR5300 handleiding
Handleiding
Je bekijkt pagina 4 van 21
iii
SAFETY TRAINING INFORMATION
WARNING
Your Icom radio generates RF
electromagnetic energy during transmit
mode. This radio is designed for and
classied as “Occupational Use Only,”
meaning it must be used only during the
course of employment by individuals
aware of the hazards, and the ways to
minimize such hazards.
This radio is NOT intended for use
by the “General Population” in an
uncontrolled environment.
• For compliance with FCC and IC RF Exposure
Requirements, the transmitter antenna installation
shall comply with the following two conditions:
1. The transmitter antenna gain shall not exceed
0 dBi.
2. IC-FR5300:
Transmit only when people are at least the
recommended minimum distance of 60
centimeters away from the properly installed
antenna. This separation distance will ensure
that there is sucient distance from a properly
installed externally-mounted antenna to satisfy
the RF exposure requirements in the applicable
RF exposure compliance standards.
2. IC-FR6300:
Transmit only when people are at least the
recommended minimum distance of 50
centimeters away from the properly installed
antenna. This separation distance will ensure
that there is sucient distance from a properly
installed externally-mounted antenna to satisfy
the RF exposure requirements in the applicable
RF exposure compliance standards.
CAUTION
To ensure that your exposure to RF
electromagnetic energy is within the
FCC and IC allowable limits for
occupational use, always adhere to the
following guidelines:
• DO NOT operate the radio without a proper antenna
attached, as this may damage the radio and may
also cause you to exceed FCC and IC RF exposure
limits. A proper antenna is the antenna supplied
with this radio by the manufacturer or an antenna
specically authorized by the manufacturer for use
with this radio.
• DO NOT transmit for more than 50% of total radio
use time (“50% duty cycle”). Transmitting more
than 50% of the time can cause FCC and IC RF
exposure compliance requirements to be exceeded.
The radio is transmitting when the “TX indicator”
lights red. You can cause the radio to transmit by
pressing the “PTT” switch.
Electromagnetic Interference/Compatibility
During transmissions, your Icom radio generates
RF energy that can possibly cause interference with
other devices or systems. To avoid such interference,
turn o the radio in areas where signs are posted to
do so. DO NOT operate the transmitter in areas that
are sensitive to electromagnetic radiation such as
hospitals, aircraft, and blasting sites.
FCC INFORMATION
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful in-
terference in a residential installation. This equipment
generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance
with the instructions, may cause harmful interference
to radio communications. However, there is no guar-
antee that interference will not occur in a particular
installation. If this equipment does cause harmful in-
terference to radio or television reception, which can
be determined by turning the equipment o and on,
the user is encouraged to try to correct the interfer-
ence by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit dif-
ferent from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV tech-
nician for help.
CAUTION: Changes or modications to this repeater, not
expressly approved by Icom Inc., could void your authority
to operate this repeater under FCC regulations.
Bekijk gratis de handleiding van Icom IC-FR5300, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Icom |
| Model | IC-FR5300 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 2740 MB |
Caratteristiche Prodotto
| Ingebouwd display | Ja |
| Vermogensverbruik (max) | 50 W |
| Ondersteunde beveiligingsalgoritmen | SNMP |
| Rack-montage | Ja |
| Aantal kanalen | 32 kanalen |
