Icom IC-A220 handleiding
Handleiding
Je bekijkt pagina 12 van 40
5
2
BASIC OPERATION
■ Receiving and transmitting
1. Setting the standby frequency
Rotate [DIAL] and [O-DIAL] to set the standby frequency.
• The active frequency is not affected.
• Rotate [O-DIAL] to set above 1 MHz digit.
• Rotate [DIAL] to set below 100 kHz digit.
• You can set the frequency step in the Settings menu. (p. 20)
126.405
134.80
MEMORY
2. Exchanging the frequency
After setting the standby frequency, push [
] to exchange it
with the active frequency.
134.805
126.40
3. Receiving
While receiving a signal, “RX” is displayed and audio is
heard.
• Rotate [VOL] to adjust the audio level.
• Adjust the squelch if necessary. See ‘Squelch settings’ for details.
134.805
126.40
RX
4. Transmitting
q Hold down PTT switch, and then speak at your normal
voice level.
• “TX” is displayed.
• DO NOT hold the microphone too closely to your mouth or
speak too loudly. This may distort your signal.
134.805
126.40
TX
w Release the PTT switch to receive.
NOTE: To prevent interference, listen on the frequency
before transmitting. If the frequency is busy, wait until it is
clear.
NOTE: DO NOT hold down [ ] continuously.
Otherwise
,
the standby frequency disappears. In this case,
hold down [
] until the standby frequency appears again.
Bekijk gratis de handleiding van Icom IC-A220, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Icom |
| Model | IC-A220 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3344 MB |
