Icom IC-7760 handleiding
Handleiding
Je bekijkt pagina 80 van 100
10-1
BASIC MANUAL
10
MAINTENANCE
Cleaning
DO NOT use harsh solvents such as
benzine or alcohol when cleaning,
because they will damage the
transceiver surfaces.
If the transceiver becomes dusty or dirty,
wipe it clean with a dry, soft cloth.
Occasionally, erroneous information may be
displayed. This may be caused by static electricity or
by other factors. If this problem occurs, turn OFF the
transceiver. After waiting a few seconds, turn ON the
transceiver again.
If the problem still exists, perform a Partial reset, as
described to the right.
If the problem still exists after a Partial reset, perform
an All reset, also described to the right.
NOTE: An All reset clears all data and returns all
settings to their factory defaults. Save memory
channel content, setting status, and so on, onto an
SD card or USB ash drive before an All reset.
After performing a Partial reset
A Partial reset resets operating settings to their default
values (VFO frequency, VFO settings, menu contents)
without clearing the items listed below:
• Pairing information of the controller and RF deck
• Memory channel/Keyer memory/RTTY memory/
PSK memory/Preset memory/Antenna memory contents
• Internal antenna tuner preset points
• DPD adjustment value (only for user adjustment values)
• Network settings • REF Adjust
• MY Call • User Band Edges
• Fixed Edges
After performing an All reset
An All reset clears all data and returns all settings to
their factory defaults. Memory channel contents, lter
settings, and so on will all be cleared, so you will need
to directly connect the controller and the RF deck with
a supplied control cable to pair them, and then rewrite
your operating settings unless you have a backup.
L The internal antenna tuner preset points are not cleared.
You can clear them in the following item.
MENU
»
SET > Function > Tuner >
<<Preset Memory Clear>>
NOTE: If the controller and RF deck connection fails
even when directly connecting then with the supplied
control cable, perform an All reset with directly
connecting them.
Resetting
When you cannot enter the Set mode
If a touch screen operation error or an unexpected
operation occurs, you cannot enter the Set mode. In
this case, perform an All reset, as described below:
1. Turn OFF the transceiver.
2. While holding down
SUB DISP
and
MPAD
, push
POWER
.
L If you cannot turn the transceiver ON or OFF by using
POWER
, perform an All reset by connecting a power
adapter while holding down
SUB DISP
and
MPAD
.
Bekijk gratis de handleiding van Icom IC-7760, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Icom |
| Model | IC-7760 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 18538 MB |
