Hyundai SI885 handleiding
Handleiding
Je bekijkt pagina 26 van 44
II. DESCRIPTION OF THE APPLIANCE (Fig. 1)
A– ironing plate I– water container
B – additional spray jet J – SELF CLEAN position
C – filling hole lid K– rest board
D – steaming regulator L – space for power cord wind-up
E – additional spray button M – power cord
F – steam shock button N – handle
G – control light O – filling cup
H – thermostat regulation wheel
III. INSTRUCTIONS FOR USE
Ironing temperatures
– Sort laundry and iron according to the instructions for treatment (e.g. manufacturer’s
recommendation - the label on clothes). If the instruction is missing and you know the
material of the clothes, follow the table on picture 3. The table applies to basic materials
only, not to possible decorations, material treatment, etc.
– Start to iron from the lowest temperatures to higher temperatures. If clothes consist of
e.g. two and more materials or if they contain stringing, purls, embossing, stretch
material, etc., always iron according to the material requiring the lower temperature only.
If you do not know the material, find the suitable place that is not visible when wearing
and try suitable temperature for ironing at the place.
Ironing without steaming
Plug the power cord M to electric socket. Put the iron to the rest position (Fig. 7). Turn the
steaming regulator D to the position, steaming off (fig. 5) or pour out water from the
container I. Set the temperature using regulation wheel H according to the selected fabric
material (Fig. 2). Reaching the required temperature is shown by turning the indicator lamp
G OFF.
Recommendation
Control H (Fig. 2) is marked with international symbols that recommend the optimum ironing
temperature and they are the same as marking on some types of laundry and textiles (Fig. 3).
Steam ironing
Hold the iron in your hand, turn the steaming regulator D to the position (Fig. 5) and
slide the cover C to open the filling container lid. Pour in water to the container I (Fig. 4)
with the enclosed cup O and close the filling hole lid in the opposite direction. Keep the
position of the iron for pouring in water. Put the iron to the rest position (Fig. 7) and set
the regulation wheel H to the marked area for steaming (Fig. 2 - ). Plug the power cord
M to a socket. When the control light G goes off, move the steaming regulator D to the
right. Place the iron to the rest position, automatic creation of steam will stop (more steam
may be going out for a short time).
Warning
– At places with hard water we recommend diluting it with distilled water. You will get
the information about water hardness at the water-management authorities, or at the
local sanitary station. For water hardness > 15 °N we recommend filling the iron in the
following ratio:
EN - 26
Bekijk gratis de handleiding van Hyundai SI885, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Hyundai |
| Model | SI885 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 4230 MB |
