Hymer Exsis I (2025) handleiding
Handleiding
Je bekijkt pagina 37 van 240
Before the journey 3
Exsis I/T - 01/23-1 - EHG-0027-02EN 37
3.6 Entrance steps
Before commencing the journey and after short interruptions of the
journey, ensure that the entrance step is completely retracted.
Do not stand in the direct range of the entrance step while it is being
retracted or extended.
Do not step on the entrance step until it has extended completely.
There is a risk of injury!
To prevent danger of slipping, clean the entrance step if necessary
before entering (snow, ice, mud, etc.).
Do not under any circumstances raise or lower persons or loads with
the entrance step.
Following a cold start, for vehicle-related reasons it can take a few
seconds before the warning tone sounds.
Observe the maximum load for the entrance step according to the
manufacturer's instruction manual.
Do not grease or lubricate the pivot bearing and joints of the entrance
step (see chapter 11).
3.6.1 Entrance step
Fig. 9 Rocker switch for entrance
step (entrance area)
Fig. 10 Rocker switch for entrance
step (dashboard)
The rocker switch in the entrance area has a covering frame (Fig. 9,1) to
protect it from being actuated unintentionally.
◼ Press the rocker switch (Fig. 9) in the entrance area or the rocker switch
(Fig. 10) on the dashboard in the driver's cabin.
◼ Press the rocker switch (Fig. 9) situated in the entrance area.
When the engine is running and the entrance step is extended, a warning
tone is heard. The warning tone stops as soon as the entrance step is re-
tracted.
Retracting:
Extending:
Bekijk gratis de handleiding van Hymer Exsis I (2025), stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Hymer |
| Model | Exsis I (2025) |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 25423 MB |
