Hymer Exsis I (2025) handleiding
Handleiding
Je bekijkt pagina 211 van 240
Wheels and tyres 13
Exsis I/T - 01/23-1 - EHG-0027-02EN 211
◼ Screw in the wheel bolts and slightly tighten them cross-wise.
◼ Crank down the vehicle jack and remove it.
◼ Using the wheel brace, tighten the wheel bolts evenly (see sec-
tion 13.6.2 for tightening torque).
13.6.4 Changing a wheel with alloy wheel rims
Alloy wheel rims and steel wheel rims require different wheel bolts.
When alloy wheel rims are mounted, the spare wheel (steel wheel rim)
is accompanied by suitable wheel bolts.
Wheels with alloy rims are changed in the same way as wheels with steel
rims (see section 13.6.3).
13.7 Tyre pressure
Tyres overheat if the tyre pressure is too low. This can cause serious
tyre damage.
Check tyre pressure before a journey or every 2 weeks. Wrong tyre
pressure causes excessive wear and can lead to damage or even to
tyre burst. You can lose control of the vehicle.
Use only valves that are approved for the specified tyre pressure.
If the tyre pressure exceeds 4.5 bar, the use of a metal or hybrid valve
is recommended.
Check the tyre pressure on cold tyres. Do not reduce the higher tyre
pressure when the tyres are warm.
The payload and the durability of tyres is directly dependent on the tyre
pressure. Air is a volatile medium. It is unavoidable that it will escape from
tyres.
As a rule of thumb it can be assumed that a filled tyre loses pressure at a
rate of 0.1 bar every two months. To prevent the tyres becoming damaged
or burst, check the tyre pressure regularly.
The information on pressure levels is valid for cold tyres and loaded ve-
hicles.
Pressure in hot tyres must be 0.3 bar higher than in cold tyres. Recheck
the pressure when the tyres are cold.
The tyre pressure tolerance is +/- 0.05 bar.
Refer to the vehicle documents or the vehicle identification plate for the
maximum permissible axle load.
Bekijk gratis de handleiding van Hymer Exsis I (2025), stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Hymer |
| Model | Exsis I (2025) |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 25423 MB |
