Hymer Exsis I (2025) handleiding
Handleiding
Je bekijkt pagina 210 van 240
13 Wheels and tyres
210 Exsis I/T - 01/23-1 - EHG-0027-02EN
Fig. 171 Storage box (on-board tool
set)
The on-board tool set is stored in a storage box (Fig. 171,1) in the rear gar-
age.
13.6.2 Tightening torque
According to Fiat, tighten all Fiat rims to 170 Nm, regardless of whether they
are steel or alloy wheel rims.
13.6.3 Changing a wheel
The footplate of the vehicle jack must be levelly positioned on the
ground.
Only drive to the nearest workshop with the spare wheel.
The wheel you have replaced should be repaired immediately.
Take note of the general instructions in this chapter.
◼ Park the vehicle on as even and stable a surface as possible.
◼ Go into first gear. In the case of automatic transmission, change gear to
"P" position.
◼ Apply the handbrake.
◼ Place chocks or other appropriate objects beneath the vehicle to secure
it.
◼ Remove the spare wheel from the spare wheel support.
◼ If the ground is soft, place a stable support such as a wooden board be-
neath the vehicle jack.
◼ Refer to the base vehicle's operating manual for the vehicle jack attach-
ment point.
◼ Using the wheel brace, turn the wheel bolts several times to loosen
them, but do not remove them.
◼ Lift the vehicle until the wheel has been lifted 2 to 3 cm above the
ground.
◼ Remove the wheel bolts and take off the wheel.
◼ Place the spare wheel on the wheel hub and adjust.
Bekijk gratis de handleiding van Hymer Exsis I (2025), stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Hymer |
| Model | Exsis I (2025) |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 25423 MB |
