Husqvarna-Viking Designer Ruby Royale Handleiding (134 Pagina's)

Handleiding

2:8

1

2

43

F

G

C

D

E

1

2

INSERTING THE BOBBIN

1. Remove the bobbin cover by sliding it towards you.

2. Place the bobbin in the bobbin case. It drops in only

one way with the logo facing up. The thread unreels

from the left of the bobbin. The bobbin will then

rotate counter-clockwise when you pull the thread.

3. Place your nger on the bobbin to keep it from

turning as you pull the thread rmly to the right and

then to the left into the tension spring (C) until it

“clicks” into place.

4. Continue threading around (D) and to the right of the

thread cutter (E). Slide on the bobbin cover (F). Pull

the thread to the left to cut (G).

CHANGING THE PRESSER FOOT

1. Make sure that the needle is in the highest position.

Pull the presser foot down and towards you.

2. Line up the cross pin on the foot with the gap in the

presser foot ankle.

3. Push the foot into the clip until the foot snaps into

place.

ATTACHING THE SENSOR Q-FOOT

1. Using the screwdriver, remove the presser foot ankle.

2. Place the Sensor Q-foot from behind, and lower

the needle into the opening of the foot by turning

the handwheel towards you. Position the foot onto

the presser foot bar so that the hole on the foot

matches the hole on the presser foot bar. The arm

of the presser foot should rest on top of the needle

screw. Insert the screw and tighten the screw with a

screwdriver.

Bekijk gratis de handleiding van Husqvarna-Viking Designer Ruby Royale, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.