Husqvarna-Viking Designer Ruby Royale Handleiding (134 Pagina's)

Handleiding

2:7Set up

A

B

BOBBIN WINDING WHILE EMBROIDERING OR

SEWING

1. Raise the auxiliary spool pin. Place the large spool cap,

felt pad and thread spool on the spool pin.

2. Bring the bobbin thread around the thread tension

disc (A) and through the thread guide (B) as illustrated.

3. Guide the thread through the hole in the bobbin from

the inside to the outside.

4. Push the bobbin winder lever towards the bobbin to

wind. A pop-up message appears on screen. To adjust

winding speed drag the arrow on the slider with your

stylus. Stop and start the bobbin winding with the

on-screen buttons. Hold the end of the thread rmly

when starting to wind.

When the bobbin is full, the bobbin winder lever will

move back and the winding willl stop automatically.

The pop-up message closes. Remove the bobbin and

cut the thread using the bobbin winding thread cutter.

Note: Make sure that the thread does not touch the cap of the

horizontal spool pin when winding the bobbin. If it does, place the cap

and spool higher on the vertical spool pin.

THREAD SENSOR

If the needle thread breaks or bobbin thread is running

low, the machine stops and a pop-up message appears on

the screen.

If needle thread breaks: Re-thread the machine and touch

OK on the pop-up message. If bobbin thread is running

low: You can continue sewing without closing the pop-up

before the bobbin thread runs out completly. This gives

you an opportunity to plan when you want to change your

bobbin. When the bobbin is replaced with a full one, touch

OK in the pop-up.

Bekijk gratis de handleiding van Husqvarna-Viking Designer Ruby Royale, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.