Humminbird NMEA 2000 handleiding
Handleiding
Je bekijkt pagina 14 van 36
14
Installation - Access Under
B. Access Under Mounting Location
Use the following instructions to deck mount the Sensor and route the cable
down through the mounting surface:
NOTE
It is important to review the mounting considerations and test run the cable route
as indicated in Section 1 before proceeding with the installation.
1. Mark the mounting location and drill a 5/8" (15.9 mm) hole for the cable
and cable connector.
2. Route the Sensor Cable through the planned cable route.
3. Cover the cable hole with the Sensor.
Position the sensor so the arrow on the cover is pointed straight toward
the front of the boat in the direction of travel. The arrow should be
parallel with the keel.
NOTE
Failure to align the sensor correctly will result in incorrect compass readings.
4. Make sure the Sensor is flush against the surface, and mark the two
mounting holes with a pencil or awl.
5. Move the Sensor to the side and drill two pilot holes, using a 5/32"
(4 mm) bit.
NOTE
Apply marine-grade silicone caulk or sealant to both screw and drilled holes as
needed to protect your boat from water damage.
Bekijk gratis de handleiding van Humminbird NMEA 2000, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Humminbird |
| Model | NMEA 2000 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3843 MB |
