Hotone Ampero II Stomp 10th Anniversary Limited Edition Handleiding (103 Pagina's)

Handleiding

Connecting pedalboards

Set your Ampero II Stomp into your pedalboard, then connect other pedals/controller depending on I/O configurations. When

Ampero II Stomp is used as your core gear, if you’re using FX loop jacks, please make sure FX loop related modules/nodes are

properly set.

Please adjust patch volume properly or volume drop will occur when bypassing/engaging your Ampero II Stomp like a pedal.

Please remember bypass mode (DSP/Analog) may alter the tone a lot (e.g. connected in front of a fuzz pedal). If tonal issue

(which may caused by impedance mismatch) occurs, try to switch to a different bypass mode.

Suggested Setups

38

DESIGN INSPI R AT I O N

Bekijk gratis de handleiding van Hotone Ampero II Stomp 10th Anniversary Limited Edition, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.