Hoover HBR 410BL8-80 handleiding
Handleiding
Je bekijkt pagina 32 van 40
Problem Cause Solution
F3
• Temperature sensor error.
• Contact the After sales service.
F4
• Heating error.
• Contact the After sales service.
F7
• Motor error.
• Contact the After sales service.
Contact the After sales service
FA
• Water level sensor error.
• Contact the After sales service.
• Abnormal communication error.
• Contact the After sales service.
•
• Contact the after sales service to replace
•
7KHLRWPRGXOHIDLOVWREHFRQƪJXUHG
•
11.3 Troubleshooting without display code
Problem Cause Solution
Washing machine
fails to operate.
• Programme is not yet started.
• Door is not properly closed.
• Machine has not been switched on.
• Power failure.
• Child lock is activated.
• Check programme and start it.
• Close the door properly.
• Switch the machine on.
• Check power supply.
• Deactivate child lock.
Washing machine
will not be ƪlled with
water.
• No water.
• Inlet hose is kinked.
• Inlet hose ƪlter is blocked.
• Water pressure is less than 0,03
MPa.
• Door is not properly closed.
• Water supply failure.
• Check water tap.
• Check inlet hose.
• Unblock inlet hose ƪOWHU
• Check water pressure.
• Close the door properly.
• Ensure the water supply.
Machine is draining
while being ƪOOHG
• Height of drain hose is below 80 cm.
• Drain hose end could reach into
water.
• Make sure that drain hose is
properly installed.
• Make sure the drain hose is not in
water.
Drainage failure.
• Drain hose is blocked.
• 3XPSƪlter is blocked.
• Drain hose end is higher than 100 cm
above ƫRRUlevel.
• Unblock drain hose.
• Clean pump ƪlter.
• Make sure that drain hose is
properly installed.
Strong vibration
while spinning.
• Not all transportation bolts have
been removed.
• Appliance has no solid position.
• Machine load is not correct.
• Remove all transportation bolts.
• Ensure solid ground and a levelled
position.
• Check load weight and balance.
Operation stops
before completing
wash cycle.
• Water or electric failure.
• Check power and water supply.
Operation stops for
a period of time.
• Appliance displays error code.
• Problem due to load pattern.
• Programme performs soaking cycle.
• Consider display codes.
• Reduce or adjust load.
• Cancel programme and restart.
5E
Drainage error.
Water is not fully drained in set time.
FC0,FC1 or
FC2
FH
the iot module.
Eb
5E
Clothes jamming alarm.
•
•
Pause operating, open the door and place
garments again before restarting.
32
11-Troubleshooting
EN
Bekijk gratis de handleiding van Hoover HBR 410BL8-80, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Hoover |
| Model | HBR 410BL8-80 |
| Categorie | Wasmachine |
| Taal | Nederlands |
| Grootte | 5606 MB |
