Homematic IP HmIPW-STH-A handleiding
Handleiding
Je bekijkt pagina 17 van 24

17
Start-up
• IP protection types;
• Installation of electrical installation
material;
• Type of supply network (TN sys-
tem, IT system, TT system) and the
resulting connecting conditions
(classical zero balancing, protective
earthing, required additional mea-
sures etc.).To integrate the tem-
perature and humidity sensor into
your system and enable it to com-
municate with other HomematicIP
devices, you must pair the device
to your HomematicIP AccessPoint
first.
Permitted cable cross sections for con-
necting to the temperature and humi-
dity sensor are:
Rigid cable: 0.12-0.50 mm
2
For reasons of electrical safety,
only the following cables must be
used for connecting to the Home-
matic IP wired bus:
• Telephone cable J-Y(ST)Y with 2
x 2 x 0.8
(= 0.5mm²) or 4 x 2 x 0.8 (= 0.5
mm²),
shielded, TP
• Ethernet installation cable S/
FUTP, Type Cat5e or higher with
2 x 2 x AWG22 (= 0.34 mm²) or
4 x 2 x AWG22 (= 0.34 mm²),
shielded, TP
The shield (continuity wire) must
be connected to “–” (=GND) at
the bus connection of the Wired
Access Point (HmIPW-DRAP). The
shield may not be connected to
the temperature and humidity
sensor.
6.2 Installation
The bus is powered by the Home-
matic IP Wired Access Point
(HmIPW-DRAP). For further infor-
mation, please refer to the opera-
ting manual of the corresponding
Wired Access Points.
To facilitate connection to the
terminals, the green push-in ter-
minal can be removed from the
device. To do this, release the
mounting plate, press the latch on
the back next to the lock symbol
and slide the clamp out of the
mounting plate to the side.
For the installation, please proceed as
follows:
• Switch o the circuit breaker of the
power circuit.
Figure 2
OFF
Bekijk gratis de handleiding van Homematic IP HmIPW-STH-A, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
Merk | Homematic IP |
Model | HmIPW-STH-A |
Categorie | Niet gecategoriseerd |
Taal | Nederlands |
Grootte | 2724 MB |