Homedics MD-1000-AU handleiding

Handleiding

12345678/ 8

Afdrukken

Je bekijkt pagina 5 van 8

5

INSTRUCTIONS FOR USE:

4

GB

AREA

Cheeks Around Lips & Chin Around Eyes Forehead Nose

MAX LEVEL 3 2 1 4 4

ROUTINE

(Level 3)

(Level 2)

(Level 1)

(Level 4)

(Level 4)

Charging the battery

When the level indictor LED ashes red, the product needs charging. Connect the

charging base to the mains using the USB power lead and the appropriate plug.

Place the handle in the charging base and press down rmly. The LED lights will

ash to indicate that charging is taking place. When charging is complete all the

lights will stay on. It takes 4 hours for a full charge, which will provide 90-120

minutes use, dependent on power levels used.

Filter Fitting and Replacement

For correct operation it is very important that a new black wool lter is tted

before each use of the device. The lter collects dead skin cells and should be

disposed of after use and then replaced. Using the device without a lter will

allow debris and dead skin cells to enter the motor, shortening the life of the

product and invalidating the guarantee. (Fig.1)

What to Expect

Regular microdermabrasion treatments can both restore and maintain a

youthful appearance to the skin. We advise starting slowly with just one or two

treatments a week, then building up to treatments every other day if desired.

During use you should feel a gentle suction eect as the tip moves across the skin

and some people may also notice the slight coarseness of the diamond tip.

Depending on your skin type, you may experience some reddening or increased

sensitivity after treatment. This is perfectly normal and usually subsides within

a few hours. You may wish to consider this and make your rst treatment at the

end of the day rather than just before going out.

Adverse reactions are rare, but if skin becomes unduly inamed or irritated, stop

using the device immediately.

Facial Treatment Routine

• Wash and dry your face

• Remove the handle from the charging base and t your choice of diamond

tip with a new black wool lter.

• Press and hold the power button for 2 seconds to turn the unit on. Press

again as required to increase the power level, as indicated by the LEDs. It is

recommended to start on level 1 for the rst treatment and to progress to a

higher level if comfortable. See also MAX recommended levels in the above

diagrams

INSTRUCTIONS FOR USE:

(Fig.1)

NOTE: Avoid the sensitive

areas immediately above

and below the eye.

CHARGING THE BATTERY

When the level indictor LED flashes red, the product

needs charging. Connect thecharging base to the

detachable supply unit model SAW06C-050-1000AB

provided with this appliance using the USB charging

cable. Place the handle in the charging base and press

down firmly. The LED lights will flash to indicate that

charging is taking place. When charging is complete

all the lights will stay on.

It takes 4 hours for a full charge, which will provide

90-120 minutes use, dependent on power levels used.

FILTER FITTING AND REPLACEMENT

For correct operation it is very important that a new

black wool filter is fitted before each use of the

device. The filter collects dead skin cells and should

be disposed of after use and then replaced. Using

the device without a filter will allow debris and dead

skin cells to enter the motor, shortening the life of the

product and invalidating the warranty. (See below)

WHAT TO EXPECT

Regular microdermabrasion treatments can both

restore and maintain a youthful appearance to the

skin. We advise starting slowly with just one or two

treatments a week, then building up to treatments

every other day if desired.

During use you should feel a gentle suction eect

as the tip moves across the skin and some people

may also notice the slight coarseness of the

diamond tip. Depending on your skin type, you may

experience some reddening or increased sensitivity

after treatment. This is perfectly normal and usually

subsides within a few hours. You may wish to consider

this and make your first treatment at the end of the day

rather than just before going out. Adverse reactions

are rare, but if skin becomes unduly inflamed or

irritated, stop using the device immediately.

FACIAL TREATMENT ROUTINE

• Wash and dry your face

• Remove handle from the charging base and fit your

choice of diamond tip with a new black wool filter.

• Press and hold the power button for 2 seconds

to turn the unit on. Press again as required to

increase the power level, as indicated by the

LEDs. It is recommended to start on level 1 for the

first treatment and to progress to a higher level if

comfortable. See also MAX recommended levels in

the above diagrams.

• Place the diamond tip flat against the skin until you

feel suction then smooth motion, covering the same

area no more than 2-3 times in one treatment. Do not

press hard. In some areas it can help to hold the skin

taught with the other hand (eg. around the eyes).

• The diagram above will help you establish an

eective facial routine.

12345678/ 8

Bekijk gratis de handleiding van Homedics MD-1000-AU, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.

Productinformatie

Gerelateerde producten van Homedics (Niet gecategoriseerd)

Handleiding bekijken

Homedics Stretch+ YMM-2000-AU

Niet gecategoriseerd - handleiding

Handleiding bekijken

Homedics Ellia Stone ARM-810-TP-AU

Niet gecategoriseerd - handleiding

Andere merken in Niet gecategoriseerd