Holzmann TW75 handleiding
Handleiding
Je bekijkt pagina 20 van 28
OPERATION
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at 20
TW75_230V | TW150_230V
14.3 Electrical connection
WARNING
Dangerous electrical voltage!
Risk of injury due to dangerous electrical voltage!
The machine may only be connected to the power supply and the associated
checks carried out by a qualified electrician or under the instruction and
supervision of a qualified electrician!
• Check, whether the neutral connection (if existing) and the protective grounding function
properly.
• Check, whether the supply voltage and the frequency correspond to the specifications of
the machine.
NOTE
Deviation of the supply voltage and frequency!
A deviation from the value of the supply voltage of ±5 % is permissible.
A short-circuit fuse must be provided in the power supply system of the machine!
• Use a supply cable that fulfils the electrical requirements (e.g. H07RN, H05RN) and take the
required cross-section of the supply cable from a current carrying capacity table. Pay
attention to the measures for protection against mechanical damage.
• Make sure that the power supply is protected by a residual current circuit breaker.
• Connect the machine only to a properly grounded outlet.
• When using an extension cable, make sure that the dimension matches the connected
load of the machine. The connection power can be found in the technical data, the
correlation of cable cross-section and cable lengths can be found in the technical literature
or obtain information from a specialist electrician.
• A damaged cable must be replaced immediately.
NOTE
Operation is only permitted with residual current device (RCD) with maximum
residual current of 30 mA.
OPERATION
Only operate the machine when it is in a perfect condition. Before each operation, a visual
inspection of the machine must be carried out. Safety devices and operating elements must be
checked carefully. Check screw connections for damage and tight fit.
15.1 Operating instructions
• Only use cleaning agents approved for the machine.
• Make sure that the pump is completely covered with cleaning fluid.
15.2 Handling
Fill in, dosing the cleaning agents
• Check drain plug for leaks
• Fill the vat with water (max. amount of cleaning fluid according to technical data)
• Add cleaning agent (dosage according to manufacturer's instructions)
• Switch on the pump so that the water mixes with the cleaning agent
Switch the pump on and off
Switch on
• Set ON-OFF-switch to Position I (1)
Switch off
• Set ON-OFF-switch to Position 0 (2)
Bekijk gratis de handleiding van Holzmann TW75, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Holzmann |
| Model | TW75 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 5764 MB |
