Holzmann ED750FDQ handleiding
Handleiding
Je bekijkt pagina 62 van 95
STORAGE
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at 62
ED750FDQ
20.1.4 Replacing the V-belt
Open the screws (1) on the cover and remove it.
Loosen the adjusting nuts (2) on the motor frame
Remove the V-belt (3) and replace the new V-belt on
the drive pulleys (4) and tighten the V-belt. The
tension is correct when the V-belt can only be pushed
through a maximum of 5 mm with the thumb
Tighten the adjusting nuts again.
Remount the cover (pay attention to the position
switch!).
20.1.5 Replacing jaws
To replace the jaws, you must open the lathe chuck with the chuck key. In the fully open
position, the jaws can then be removed one by one.
The following must be observed when
inserting the jaws:
The threaded segments (2) of the
jaws are graduated as shown in the
figure.
In addition, they are numbered (1)
from 1 to 3 to indicate the actual
pitch in the lathe chuck.
Therefore, make sure to mount the jaws in the correct order:
1. Arrange the jaws as shown in the figure above and insert them clockwise into the slots of
the lathe chuck in this order.
2. Hold the jaws and clamp them with the chuck key.
3. Close the chuck completely and check that the jaws meet in the middle.
If a jaw does not fit properly, open the lathe chuck, press firmly on the jaw and turn the chuck
key until the jaw is in the correct position. Check again that the jaws meet in the middle.
21 STORAGE
NOTICE
Improper storage can damage and destroy important components. Only store packed
or unpacked parts under the intended environmental conditions!
When the machine is not in use, store it in a dry, frost-proof and lockable place to prevent the
formation of rust on the one hand and to ensure that unauthorised persons and in particular
children have no access to the machine on the other hand.
Bekijk gratis de handleiding van Holzmann ED750FDQ, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Holzmann |
| Model | ED750FDQ |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 33097 MB |
