Holzmann CTF45P handleiding
Handleiding
Je bekijkt pagina 32 van 58
TROUBLESHOOTING
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at 32
CTF45P_230V
• Remove chips and dirt particles from the machine after each use with a proper tool.
• Do not use compressed air or your mouth to remove the chips from the machine. To do
this, use the delivered brush.
16.2 Maintenance
The machine is low-maintenance and only a few parts need to be serviced. Malfunctions or defects
that could affect your safety must be repaired immediately!
• Before each operation, check the perfect condition of the safety devices.
• Regularly check the perfect and legible condition of the warning and safety labels of the
machine.
• Use only proper and suitable tools.
• Use only original spare parts recommended by the manufacturer.
Maintenance plan
The type and degree of machine wear depends to a large extent on the operating conditions. The
following intervals apply when the machine is used within the technical limits:
Interval
Components
Action
before usage
working table
clean
once a week
cables, lines
check
if required
guide rails
check, clean
spindle
check, clean
Spindle adjustment
After long term use, the screw travel of the spindle may be
abnormal. So you have to remove the side cover of the
machine, loosen both fixing screws (1) ( the spring returns to
its original position) and then tighten the screws again and
remount the side cover.
16.3 Storage
Store the machine in a dry, frost-proof and lockable place when not in use. Disconnect the
machine from the power supply. Make sure that unauthorised persons and especially children do
not have access to the machine.
NOTE
Improper storage can damage and destroy important components. Only store packed
or already unpacked parts under the intended ambient conditions!
16.4 Disposal
Observe the national waste disposal regulations. Never dispose of the
machine, machine components or operating equipment in the residual waste.
If necessary, contact your local authorities for information regarding available
disposal options.
If you purchase a new machine or equivalent equipment from your specialist
dealer, p32-he is obliged in certain countries to dispose of your old machine
properly.
TROUBLESHOOTING
WARNING
Danger due to electrical voltage!
Handling the machine with connected power supply may result in serious injury or
death.
Disconnect the machine from the power supply before starting work to
eliminate defects!
Many possible sources of error can be eliminated in advance if the machine is properly connected
to the power supply.
If you are unable to carry out the necessary repairs properly and/or do not have the required
training, always consult a specialist to solve the problem.
Trouble
Possible cause
Solution
motor does not run
wiring incorrect
control the wiring to the motherboard
no power supply
check power supply
limit switch does not work
wiring incorrect
control the wiring to the motherboard
display does not work
cable loose
control the cable and reconnect
wiring incorrect
change the row line sequence
SD card cannot be read
SD card incompatible
format the card on the computer and save
the file again
SD card dirty
clean contact surface carfully and try again
Bekijk gratis de handleiding van Holzmann CTF45P, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Holzmann |
| Model | CTF45P |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 13939 MB |
