Holzmann CTF45P handleiding
Handleiding
Je bekijkt pagina 29 van 58
OPERATION
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at 29
CTF45P_230V
Movement test before
NOTE: A movement test of the machine must be carried out before initial commissioning! If the
test is completed successfully, you can proceed further.
During the reference run, ensure that no connecting cables are clamped or disconnected. In an
emergency, use the emergency stop button!
• Switch the machine on
• In the "Tool" main menu (1), press the "Home" button
(2) so that a reference run is carried out and the spindle
head (3) moves to the left front corner (4) (next to the
control panel) of the machine and automatically moves
to the end positions of the axis X-, Y-, Z+
• All end positions are monitored with limit switches.
After one of these has been triggered, it must be
unlocked again using the button on the control panel.
Mount spindle motor
Position Z-axis
• Switch the machine on
• Move the Z axis (1) downwards by pressing the “Z-”
button on the control panel
• Continue the travel path until the drill holes (3) for the
motor mount are accessible
• Switch off the machine
• Fasten the motor protection bracket (1) to the Z axis
with 4 pan head screws M5x8
• Fasten the motor mount (2) with 2 screws M5x12
• Place the spindle motor (3) into the motor holder and
fix it with the lath (5) and two M5x12 screws
• Put on the motor protection
• Plug the connection cable (6) to the Z-axis “775”
Spindle motor test
CAUTION: Before carrying out the spindle motor test, you must ensure that all loose
components are tight and that there are no objects near the spindle! Always keep enough
distance from all rotating components!
• Make sure that motor connection cable is connected
to Z-axis “775” (1)
• Switch machine on
• Activate the spindle by pressing the button “Spindle”(2)
• Deactivate the spindle by pressing it again
• Switch machine off
NOTE: If the function test does not work, check the wiring from the motor to the Z-axis and
repeat the test.
Mount the workpiece
• Place the workpiece (1) on the operating surface and
clamp it by using the clamps (2) to the operating
surface.
• Align the workpiece so that you can screw the screws
of the clamp (3) into the threads of the operating
surface.
• Finally, tighten the wing nut (4) of the brackets to
clamp the workpiece.
CAUTION: Do not start machining while the workpiece is still loose and has not been properly secured!
Mount the milling cutter
NOTE: The diameter of the milling cutter shaft and the collet chuck must be identical!
Bekijk gratis de handleiding van Holzmann CTF45P, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Holzmann |
| Model | CTF45P |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 13939 MB |
