Hobart PW20N-ADV handleiding
Handleiding
Je bekijkt pagina 12 van 116
– 12 –
CLEARANCE
HEIGHT
LENGTH
WIDTH
VENTING REQUIREMENTS
For PW10n-BAS and PW20n-BAS models, Type II canopy hoods are required. Hoods must
be installed according to the manufacturer's instructions. Make-up air must be provided so
thattheexhaustowrateresultsinanegativebuildingpressureintheroomwheretheunit
is located (more exhaust air than outside air). Factory-built hoods not tested to UL standard
710andcustom-builthoodsmustcomplywiththefollowingspecications:stainlesssteel
should have a minimum thickness of 0.037 in. (0.94 mm) [No. 20 Gauge] or copper sheet
weighing at least 24 ounces per square foot (7 Kg/m2); the hood must be secured in place by
noncombustible supports and must meet the RATE of EXHAUST FLOW CALCULATIONS.
Ensure the installation meets local codes.
Canopy Size and Location
The inside lower edge of canopy-type Type II commercial hoods shall overhang or extend a
horizontal distance of not less than 6 inches (152 mm) beyond the edge of the top horizontal
surface of the appliance on all open sides. The vertical distance between the front lower
lip of the hood and such surface shall not exceed 4 feet (1219 mm) with a minimum of 1
foot (305 mm).
18” minimum overhang of the front opening.
Rate of Exhaust Flow Calculations
Based on the 2021 International Mechanical Code.
TheminimumnetairowforTypeIIhoodsusedfordishwashingappliancesshallbe100
cfm per linear foot of hood length. The net quantity of exhaust air shall be calculated by
subtractinganyairowsupplieddirectlytoahoodcavityformthetotalexhaustowrateof
a hood.
Fig. 11
Bekijk gratis de handleiding van Hobart PW20N-ADV, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Hobart |
| Model | PW20N-ADV |
| Categorie | Vaatwasser |
| Taal | Nederlands |
| Grootte | 27655 MB |
